2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

C1626 Steering Angle Sensor Failure

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates an internal malfunction.
DTC No.
DTC Detection Condition
Trouble Area
C1626
A fail flag is transmitted from the steering angle sensor.
  1. Steering sensor (spiral with sensor cable sub-assembly)
  2. Parking assist ECU

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the display and navigation module display after the battery terminal disconnected, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).


1. REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
  1. Replace the spiral with sensor cable sub-assembly (Click here).


NEXT


2. CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC C1626 is output
    A
    No DTC is output
    B



B
END
A

REPLACE PARKING ASSIST ECU (Click here)


← C1625 Open or Short in Steering Angle Sensor +B (Sep 2011 – Dec 2011)C1649 Lost Communication with VGRS ECU (Sep 2011 – Dec 2011) →