C1625 Open or Short in Steering Angle Sensor +B
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates a power supply system problem.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1625 |
Open or short in steering angle sensor +B |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When "System initializing" is displayed on the display and navigation module display after the battery terminal disconnected, correct the steering angle neutral point (Click here).
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When "System initializing" is displayed on the display and navigation module display after the battery terminal disconnected, correct the steering angle neutral point (Click here).
| 1. CHECK HARNESS AND CONNECTOR (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY POWER SUPPLY) |
Disconnect the E43 connector from the steering sensor.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E11-2 (ESS) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
E11-1 (IG) - E11-2 (ESS)
Engine switch on (IG)
11 to 14 V
E11-3 (BAT) - E11-2 (ESS)
Always
11 to 14 V
Text in Illustration *1
Front view of wire harness connector
(to Steering Sensor)
|
|
||||
| OK | ||
| ||
