B225C Tail Gate Panel Position Switch LH
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
The No. 2 main body ECU receives the close position switch signal from the lower tail gate lock assembly LH and detects the open/closed status of the lower tail gate. DTC B225C is stored when the No. 2 main body ECU receives a close position switch malfunction signal from the lower tail gate lock assembly LH.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B225C |
A close position switch malfunction (open or short circuit) signal from the lower tail gate lock LH is received. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (POSITION SWITCH LH) |
Check the Data List for proper functioning of the close position switch (Click here).
Body No. 4 Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Position Switch LH
Close position switch LH signal / ON or OFF
ON: Lower tail gate closed
OFF: Lower tail gate open
-
- OK:
- The display is as specified in the normal condition.
|
|
||||
| OK | |
| 2. CHECK DTC OUTPUT |
Starting with the lower tail gate closed, open and close the lower tail gate 6 times.
Check for DTCs (Click here).
Clear the DTCs (Click here).
Starting with the lower tail gate closed, open and close the lower tail gate 6 times.
Recheck for DTCs (Click here).
- OK:
- DTC B225C is not output.
|
|
||||
| OK | ||
| ||
| 3. INSPECT LOWER TAIL GATE LOCK ASSEMBLY LH |
Remove the lower tail gate lock assembly LH (Click here).
Inspect the lower tail gate lock assembly LH (Click here).
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (LOWER TAIL GATE LOCK ASSEMBLY LH - NO. 2 MAIN BODY ECU AND BODY GROUND) |
Disconnect the h5 lower tail gate lock assembly LH connector.
Disconnect the L51 No. 2 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
h5-7 (HND) - L51-10 (LMT)
Always
Below 1 Ω
h5-8 (GND) - Body ground
Always
Below 1 Ω
h5-7 (HND) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
