Home › Engine / Hybrid System › 1VD-FTV (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052779 1VD-FTV ENGINE MECHANICAL _0255069 REAR CRANKSHAFT OIL SEAL A

1VD-FTV ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11381A 1.INSTALL REAR CRANKSHAFT OIL SEAL

a.
U163088E02
1.229,0.625 1.635,0.865 1.635,0.865 1.75,0.865 false 1.167,1.25 1.75,1.25 true 1.094,2.917 1.677,2.917 true 0.74,2.844 1.219,3.135 0.479,0.292 10 true SST 1.604,0.26 1.729,0.406 0.125,0.146 10 false A 1.76,0.781 1.948,0.938 0.188,0.156 10 false *1 1.76,1.177 1.948,1.333 0.188,0.156 10 false *2

Using SST and a hammer, tap in a new oil seal as shown in the illustration.

SST
09223-56010  

Standard depth A:

2.7 to 3.7 mm (0.106 to 0.147 in.)


Text in Illustration
*1 Rear Engine Oil Seal Retainer
*2 Oil Seal

NOTICE:
·

Keep the lip free from foreign matter.

·

Do not tap on the seal at an angle.

·

Make sure that the lip of the oil seal is properly installed.




Hide 32101 2.INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

Hide 13405 3.INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

Hide 31250 4.INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 31210 5.INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)

Hide 33030 7.INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


a.

Connect the cables to the negative (-) main battery and sub-battery terminals.