16400
1.INSTALL RADIATOR ASSEMBLY
Insert the radiator bracket hooks into the radiator support holes.
Install the radiator with the 4 bolts.
16572D
2.INSTALL NO. 2 RADIATOR HOSE
16711
3.INSTALL FAN SHROUD
Install the fan pulley to the engine water pump.
Place the shroud together with the fluid coupling fan between the radiator and engine.
Be careful not to damage the radiator core.
Temporarily install the fluid coupling fan to the fluid coupling bracket with the 4 nuts. Tighten the nuts as much as possible by hand.
Attach the claws of the shroud to the radiator as shown in the illustration.
Install the shroud with the 2 bolts.
Connect the oil cooler tube to the fan shroud with the 2 bolts.
w/ Air Cooled Transmission Oil Cooler:
Pass the hose through the flexible hose clamp and close the clamp as shown in the illustration.
Connect the reservoir hose to the upper radiator tank.
Install the fan and generator V belt (See page Engine / Hybrid System>1UR-FE (ENGINE MECHANICAL)>DRIVE BELT>INSTALLATION).
Tighten the 4 nuts of the fluid coupling fan.
16571C
4.INSTALL NO. 1 RADIATOR HOSE
5.INSTALL AIR CLEANER CAP AND HOSE
11209
6.INSTALL V-BANK COVER SUB-ASSEMBLY
7.ADD ENGINE COOLANT
8.INSPECT FOR COOLANT LEAK
53294C
9.INSTALL RADIATOR SIDE DEFLECTOR LH
Install the deflector with the 4 clips.
53293C
10.INSTALL RADIATOR SIDE DEFLECTOR RH (w/o Air Cooled Transmission Oil Cooler)
Install the deflector with the 4 clips.
32917
11.INSTALL TRANSMISSION OIL COOLER AIR DUCT (w/ Air Cooled Transmission Oil Cooler)
Install the oil cooler air duct with the 4 bolts.
51405C
12.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
52119A
13.INSTALL FRONT BUMPER COVER (w/ Winch)
52119A
14.INSTALL FRONT BUMPER COVER (for Standard)