32910
1.INSTALL OIL COOLER ASSEMBLY
Connect the oil cooler inlet hose and outlet hose.
Install the rear transmission oil cooler air duct with the 4 bolts, and then install the air cooled oil cooler tube to the transmission oil cooler air duct with the bolt.
Temporarily put the oil cooler on the radiator support.
Securely attach the 2 claws of the oil cooler into the holes of the radiator support.
Install the 4 bolts in the sequence shown in the illustration.
32917
2.INSTALL TRANSMISSION OIL COOLER AIR DUCT
Install the oil cooler air duct with the 4 bolts.
32907A
3.INSTALL OIL COOLER TUBE SUB-ASSEMBLY
Temporarily install the oil cooler tube to the fan shroud with bolt A. Install bolt B and tighten it to the specified torque. Then tighten bolt A to the specified torque.
32941H
4.CONNECT INLET NO. 4 OIL COOLER HOSE
Connect the inlet oil cooler hose as shown in the illustration.
Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.
32941G
5.CONNECT INLET NO. 2 OIL COOLER HOSE AND INLET NO. 3 OIL COOLER HOSE
Connect the 2 transmission oil cooler hoses as shown in the illustration.
Make sure the pinching portion of each clip is facing the direction shown in the illustration.
32941
6.CONNECT INLET NO. 1 OIL COOLER HOSE AND OUTLET NO. 1 OIL COOLER HOSE
Connect the 2 oil cooler hoses as shown in the illustration.
Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.
Pass the hose through the flexible hose clamp and close the clamp shown in the illustration.
32943B
7.CONNECT TRANSMISSION OIL COOLER HOSE
Connect the 2 transmission oil cooler hoses as shown in the illustration.
Make sure the pinching portion of each clip is facing the direction shown in the illustration.
8.ADD AUTOMATIC TRANSMISSION FLUID
Add automatic transmission fluid (See page Drivetrain>A750F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION FLUID>ADJUSTMENT).
52521
9.INSTALL FRONT UPPER CENTER BUMPER RETAINER
for Standard: (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(w/ Winch)>INSTALLATION)
w/ Winch: (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(for Standard)>INSTALLATION)
53784
10.INSTALL FRONT FENDER APRON TRIM PACKING C
53782
11.INSTALL FRONT FENDER APRON TRIM PACKING A
51442
12.INSTALL NO. 2 ENGINE UNDER COVER
51405A
13.INSTALL NO. 1 ENGINE UNDER COVER
53806
14.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
53805
15.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH