Home › Drivetrain › A750F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION ASSEMBLY(for 1GR-FE) › 2014.08–2015.08
RM2660E _52 Drivetrain _052806 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0255285 AUTOMATIC TRANSMISSION ASSEMBLY(for 1GR-FE) A

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION ASSEMBLY(for 1GR-FE)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53806 3.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 4.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 51405A 6.REMOVE NO. 1 ENGINE UNDER COVER

Hide 53783 7.REMOVE FRONT FENDER APRON TRIM PACKING B

Hide 53785B 8.REMOVE FRONT FENDER APRON TRIM PACKING D

Hide 53782 9.REMOVE FRONT FENDER APRON TRIM PACKING A

Hide 53784 10.REMOVE FRONT FENDER APRON TRIM PACKING C

Hide 37140 12.REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Hide 37110 13.REMOVE PROPELLER SHAFT ASSEMBLY

Hide 33702B 15.DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

C170828

a.

Remove the clip and pin, and disconnect the gear shifting rod from the transmission control shaft lever RH.


Hide 28100 16.REMOVE STARTER ASSEMBLY

Hide 32101A 17.REMOVE DRIVE PLATE AND TORQUE CONVERTER CLUTCH SETTING BOLT

a.
C157017

Turn the crankshaft to gain access to the 6 bolts and remove each bolt while holding the crankshaft pulley setting bolt with a wrench.


Hide 18.SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY

C159641

a.

Support the transmission with a transmission jack. Lift the transmission slightly from the crossmember.


Hide 51203 19.REMOVE NO. 2 FRAME CROSSMEMBER SUB-ASSEMBLY

C171484

a.

Remove the engine mounting hole cover.


b.
C171489

Remove the 4 bolts of the rear engine mounting insulator.


c.
U164644

Remove the 4 nuts, 4 bolts and frame crossmember.


Hide 12371 20.REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR

a.
C171491

Remove the 4 bolts and rear engine mounting insulator from the transmission.


Hide 21.DISCONNECT WIRE HARNESS AND CONNECTOR

C171503

a.

Remove the bolt and disconnect the ground cable.


b.
C157274

Tilt the transmission downward.

NOTICE:

Make sure the cooling fan does not contact the fan shroud.



c.

Disconnect the park/neutral position switch connector, transmission wire connector, 2 transmission speed sensor connectors and 2 transfer control side connectors.

U164645

HINT:

Detach the claw, press down the lever, and then disconnect the transmission wire connector.



d.

Disconnect the 2 connector clamps and 6 harness clamps.


e.

Remove the bolt and disconnect the wire harness.


Hide 17118 22.REMOVE MANIFOLD STAY

C171485

a.

Remove the 3 bolts and stay.


Hide 17119 23.REMOVE NO. 2 MANIFOLD STAY

C171486

a.

Remove the 3 bolts and stay.


Hide 35104V 24.DISCONNECT BREATHER PLUG HOSE

C171499

a.

Disconnect the breather plug hose and detach the transfer breather hose.


Hide 32907A 25.DISCONNECT OIL COOLER TUBE

C358390

a.

Remove the 2 bolts and disconnect the 2 hoses from the transmission, and separate the oil cooler tube from the engine.


Hide 35000 26.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

C171497

a.

Remove the 9 bolts and transmission.

NOTICE:

Do not use excess force when prying the transmission assembly.



Hide 36100 27.REMOVE TRANSFER ASSEMBLY

C171500

a.

Detach the 2 breather hose clamps from the automatic transmission breather tube.


b.

Disconnect the clamp of the ground cable from the transfer case lower protector.


c.
C171493

Remove the 7 bolts and transfer case lower protector.


d.
C171523

Remove the 8 bolts and transfer.


Hide 32000 28.REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY