Home › Drivetrain › JF2A (TRANSFER / 4WD / AWD) › TRANSFER SYSTEM › from 2015.08
RM2660E _52 Drivetrain _052810 JF2A TRANSFER / 4WD / AWD _0255329 TRANSFER SYSTEM C

JF2A TRANSFER / 4WD / AWD  TRANSFER SYSTEM  P17A8  Transfer Shift Motor Control Circuit Circuit Open  


DESCRIPTION

This DTC is output when an open circuit is detected in the high-low transfer shift motor drive circuit.

DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
P17A8
1.

When switching between high and low or during switching operation (high-low transfer shift motor operating) with ignition switch turned to ON

2.

Open circuit in the high-low transfer shift motor drive circuit

3.

0.03 seconds or more

4.

1 trip detection logic


·

Wire harness and connector

·

4 wheel drive control ECU

·

Transfer shift actuator assembly



WIRING DIAGRAM

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - TRANSFER SHIFT ACTUATOR ASSEMBLY)
a.

Disconnect the A28 4 wheel drive control ECU connector.


b.

Disconnect the C38 transfer shift actuator assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A28-2 (HM1) - C38-1 (HM1) Always Below 1 Ω
A28-6 (HM2) - C38-2 (HM2) Always Below 1 Ω




OK

2.INSPECT TRANSFER SHIFT ACTUATOR ASSEMBLY (HIGH-LOW TRANSFER SHIFT MOTOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT TRANSFER SHIFT ACTUATOR ASSEMBLY (HIGH-LOW TRANSFER SHIFT MOTOR)
C339630E04
2.135,1.26 1.854,1.823 false 2.354,1.271 2.792,1.708 false 0.125,0 0.656,0.313 0.531,0.313 10 false *a 0.417,0.969 0.719,1.198 0.302,0.229 10 false *b 1.677,1.823 2.073,2.021 0.396,0.198 10 false HM2 2.677,1.729 3.073,1.927 0.396,0.198 10 false HM1

a.

Disconnect the C38 transfer shift actuator assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HM1) - 2 (HM2) Always 1.5 to 100 Ω


Text in Illustration
*a Component without harness connected
(Transfer Shift Actuator Assembly)
*b High-low Transfer Actuator Side

Result:
Result Proceed to
OK for LHD A
for RHD B
NG C




A

B

C

REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY