Home › Drivetrain › JF2A (TRANSFER / 4WD / AWD) › TRANSFER SYSTEM › from 2015.08
RM2660E _52 Drivetrain _052810 JF2A TRANSFER / 4WD / AWD _0255329 TRANSFER SYSTEM C

JF2A TRANSFER / 4WD / AWD  TRANSFER SYSTEM  P17DE  Center Differential Lock Shift Motor Circuit Open  


DESCRIPTION

This DTC is output when an open circuit in the center differential shift motor drive circuit is detected.

DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
P17DE
1.

When switching between free and lock or during switching operation (center differential lock shift motor operating) with ignition switch turned to ON

2.

Open circuit in the center differential lock shift motor drive circuit

3.

0.03 seconds or more

4.

1 trip detection logic


·

Wire harness and connector

·

4 wheel drive control ECU

·

Transfer shift actuator assembly



WIRING DIAGRAM

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - TRANSFERSHIFT ACTUATOR ASSEMBLY)
a.

Disconnect the A28 4 wheel drive control ECU connector.


b.

Disconnect the C37 transfer shift actuator assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A28-8 (TM1) - C37-1 (TM1) Always Below 1 Ω
A28-7 (TM2) - C37-2 (TM2) Always Below 1 Ω




OK

2.INSPECT TRANSFER SHIFT ACTUATOR ASSEMBLY (CENTER DIFFERENTIAL LOCK SHIFT MOTOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT TRANSFER SHIFT ACTUATOR ASSEMBLY (CENTER DIFFERENTIAL LOCK SHIFT MOTOR)
C339631E02
0.121,0 0.509,0.239 0.387,0.239 10 *a 0.184,0.878 0.535,1.145 0.350,0.267 10 *b 2.213,1.153 1.754,1.645 false 1.521,1.652 1.931,1.862 0.411,0.209 10 TM2 2.266,1.641 2.676,1.850 0.411,0.209 10 TM1 2.411,1.149 2.463,1.614 false

a.

Disconnect the C37 transfer shift actuator assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (TM1) - 2 (TM2) Always 1.5 to 100 Ω

Text in Illustration
*a Component without harness connected
(Transfer Shift Actuator Assembly)
*b Center Differential Lock Actuator Side


Result:
Result Proceed to
OK for LHD A
for RHD B
NG C




A

B

C

REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY