1.DRAIN TRANSFER OIL
37140
2.REMOVE FRONT PROPELLER SHAFT ASSEMBLY
33309C
3.REMOVE FRONT OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
36111B
4.REMOVE FRONT TRANSFER CASE OIL SEAL
Using SST, remove the front transfer case oil seal.
Be careful not to damage the front transfer case oil seal and front transfer case contact surface.
Apply grease to the tip of SST center bolt before use.
36111B
5.INSTALL FRONT TRANSFER CASE OIL SEAL
Apply transfer oil to the spline of the driven sprocket.
Using SST and a hammer, tap in a new front transfer case oil seal.
The front transfer case oil seal should be installed completely.
33309C
6.INSTALL FRONT OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
37140
7.INSTALL FRONT PROPELLER SHAFT ASSEMBLY
8.ADD TRANSFER OIL
9.CHECK FOR TRANSFER OIL LEAK