Home › Drivetrain › JF2A (TRANSFER / 4WD / AWD) › 4WD CONTROL ECU (for LHD) › from 2015.08
RM2660E _52 Drivetrain _052810 JF2A TRANSFER / 4WD / AWD _0255341 4WD CONTROL ECU(for LHD) A

JF2A TRANSFER / 4WD / AWD  4WD CONTROL ECU(for LHD)  INSTALLATION  


PROCEDURE

Hide 89533 1.INSTALL 4 WHEEL DRIVE CONTROL ECU

a.

Connect the 2 connectors to the 4 wheel drive control ECU.


b.

Attach the 2 guides.


c.

Install the 4 wheel drive control ECU with the bolt.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


Hide 55433B 3.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 55476A 5.INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55312 6.INSTALL LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)

Hide 73990 7.INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

Hide 55607 9.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 55403C 11.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Hide 55448A 12.INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).