Home › Suspension › SUSPENSION CONTROL › ACTIVE HEIGHT CONTROL SUSPENSION › 2014.08–2015.08
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255367 ACTIVE HEIGHT CONTROL SUSPENSION T

SUSPENSION CONTROL  ACTIVE HEIGHT CONTROL SUSPENSION  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Active Height Control Suspension
Symptom Suspected Area See page
Lifting up position of height control indicator does not change according to operation of height control switch Check that the height control is not off. -
Check test mode DTC (Click here)
Indicator circuit (Click here)
Vehicle height control function does not operate Check test mode DTC (Click here)
ECU power source circuit (Click here)
Indicator circuit (Click here)
Height control function is normal, but vehicle height is uneven Initialization (Click here)
Height control sensor link -
Suspension control ECU (Click here)
Drivability problem Fluid leakage (Click here)
Center suspension control cylinder (Click here)