Home › Suspension › SUSPENSION CONTROL › ACTIVE HEIGHT CONTROL PUMP AND MOTOR
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255369 ACTIVE HEIGHT CONTROL PUMP AND MOTOR A

SUSPENSION CONTROL  ACTIVE HEIGHT CONTROL PUMP AND MOTOR  INSTALLATION  


PROCEDURE

Hide 48910A 1.INSTALL HEIGHT CONTROL PUMP AND MOTOR ASSEMBLY

a.
C172732

Install the pump and motor with the 3 bolts.

Torque:
31 N*m (316 kgf*cm, 23 ft.*lbf)


b.
C172672

Connect the 2 connectors and 3 clamps.


Hide 48965 2.INSTALL HEIGHT CONTROL TUBE CLAMP

a.
C176840E01
0.06,0.384 0.980,0.721 0.921,0.337 10 Height Control Tube Clamp 1.178,0.484 1.824,0.484 false

Install the tube clamp with the 2 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Connect the reservoir hose to the tube clamp.


Hide 48999 3.CONNECT REAR NO. 6 HEIGHT CONTROL TUBE

a.
C176223E01
2.076,3.2 3.082,3.343 1.006,0.143 10 Fulcrum Length 0.253,2.317 0.911,2.651 0.658,0.334 10 Union Nut Wrench 1.4,1.977 0.689,2.09 false 0.689,2.09 0.689,2.306 false

Using a union nut wrench, connect the control tube to the pump and motor.

Torque:
without union nut wrench : 15 N*m (155 kgf*cm, 11 ft.*lbf)
with union nut wrench : 14 N*m (143 kgf*cm, 10 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).

·

The torque value for use with a union nut wrench is effective when the union nut wrench is parallel to the torque wrench.




Hide 77277R 7.INSTALL FUEL TANK FILLER PIPE PROTECTOR

a.
C172735

Using a T30 "TORX" socket wrench, install the pipe protector with the 3 screws and grommet.


b.

Install the new grommet.


Hide 58723B 8.INSTALL NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

C179456

a.

Install the protector with 2 new grommets.


b.

Install the 2 screws.


Hide 52159 9.INSTALL REAR BUMPER COVER

a.

for Standard:

Install the bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(for Standard)>INSTALLATION).


b.

w/ Towing Hitch:

Install the bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (w/ Towing Hitch)>INSTALLATION).


c.

w/ Pintle Hook:

Install the bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(w/ Pintle Hook)>INSTALLATION).


d.

for Double Swing Out Type:

Install the bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(for Double Swing Out Type)>INSTALLATION).


Hide 76625G 10.INSTALL REAR QUARTER PANEL MUDGUARD RH