Home › Suspension › REAR SUSPENSION › REAR UPPER ARM › 2014.08–2015.08
RM2660E _53 Suspension _052816 REAR SUSPENSION _0255391 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 48790 1.TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH (w/ Active Height Control)

a.
C174363

Temporarily install the rear upper control arm and 2 washers with the 2 bolts and 2 nuts.


Hide 48790 2.TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH (w/o Active Height Control)

a.
C178733

Temporarily install the rear upper control arm and 2 washers with the 2 bolts and 2 nuts.


Hide 48790 4.TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH

a.

Tighten the 2 nuts.

Torque:
150 N*m (1530 kgf*cm, 111 ft.*lbf)

NOTICE:

Perform this procedure with all 4 wheels on the ground.



Hide 48884 5.INSTALL REAR STABILIZER CONTROL TUBE INSULATOR (w/ KDSS)

a.
C174360

Install the rear stabilizer control tube insulator with the 2 bolts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 48691A 6.INSTALL UPPER ARM BUSH HEAT INSULATOR (w/o KDSS)

a.
C180039

Install the upper arm bush heat insulator with the bolt.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 7.CONNECT SPEED SENSOR WIRE HARNESS

a.
C174362

Connect the speed sensor wire harness with the bolt.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


Hide 89408D 8.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Active Height Control)

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Active Height Control)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 10.PERFORM VEHICLE OFF SET CALIBRATION (w/ Active Height Control)

a.

Perform the vehicle off set calibration (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).


Hide 89408D 11.ADJUST REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Active Height Control)

Hide 48860D 13.CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

Hide 48826D 14.INSTALL STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

Hide 15.ADJUST HEADLIGHT ASSEMBLY (w/ Active Height Control)