Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD) › 2014.08–2015.08
RM2660E _54 Brake _052820 BRAKE SYSTEM (OTHER) _0255424 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.
C177106E01
0.034,0.006 2.153,0.203 2.119,0.198 12 for Automatic Transmission: 0.061,2.292 2.180,2.489 2.119,0.198 12 for Manual Transmission: 1.408,1.666 1.223,1.894 false

Install the brake pedal support assembly with the 4 nuts.

Torque:
14 N*m (145 kgf*cm, 10 ft.*lbf)


b.
U165102E01
0.086,0.086 2.186,0.263 2.100,0.177 12 for Automatic Transmission: 0.088,2.342 2.014,2.518 1.927,0.177 12 for Manual Transmission:

Install the brake pedal support reinforcement set bolt.

Torque:
16 N*m (163 kgf*cm, 12 ft.*lbf)


c.

Tighten the hexagon bolt.

Torque:
23 N*m (239 kgf*cm, 17 ft.*lbf)

HINT:

Hold the bolt in place and tighten the nut.



Hide 47264A 2.INSTALL PUSH ROD PIN

a.

Apply a light coat of lithium soap base glycol grease to the inner surface of the hole on the brake pedal lever.


b.
C177105E03
0.052,0.052 2.156,0.26 2.104,0.208 12 false for Automatic Transmission: 0.052,2.365 1.958,2.604 1.906,0.24 12 false for Manual Transmission:

Set the master cylinder push rod clevis in place, insert the push rod pin from the outside of the vehicle and then install a new clip.


Hide 84340 3.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.

Install the stop light switch (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>INSTALLATION).


b.

Connect the stop light switch connector.


Hide 55432D 5.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 55606 6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).