Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD) › from 2015.08
RM2660E _54 Brake _052820 BRAKE SYSTEM (OTHER) _0255424 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.
C177106E02
0.133,0.088 0.363,0.286 0.230,0.198 10 *A 0.133,2.305 0.363,2.503 0.230,0.198 10 *B 1.408,1.637 1.223,1.865 false

Install the brake pedal support assembly with the 4 nuts.

Text in Illustration
*a for Automatic Transmission
*B for Manual Transmission

Torque:
14 N*m (145 kgf*cm, 10 ft.*lbf)


b.
U165103E01
0.142,0.137 0.367,0.314 0.225,0.177 10 *A 0.142,2.38 0.367,2.557 0.225,0.177 10 *B

Install the brake pedal support reinforcement set bolt.

Text in Illustration
*a for Automatic Transmission
*B for Manual Transmission

Torque:
16 N*m (163 kgf*cm, 12 ft.*lbf)


c.

Tighten the hexagon bolt.

Torque:
23 N*m (239 kgf*cm, 17 ft.*lbf)

HINT:

Hold the bolt in place and tighten the nut.



Hide 47264A 2.INSTALL PUSH ROD PIN

a.

Apply a light coat of lithium soap base glycol grease to the inner surface of the hole on the brake pedal lever.


b.
C177105

Set the master cylinder push rod clevis in place, insert the push rod pin from the outside of the vehicle and then install a new clip.

Text in Illustration
*a for Automatic Transmission
*B for Manual Transmission


Hide 84340 3.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.

Install the stop light switch (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>INSTALLATION).


b.

Connect the stop light switch connector.


Hide 82666A 4.INSTALL NO. 2 CONNECTOR HOLDER

a.
C347212E01
1.844,1.688 1.979,1.865 0.135,0.177 10 true A 1.125,0.479 1.26,0.656 0.135,0.177 10 true B 2.031,0.49 2.167,0.667 0.135,0.177 10 true B

Attach the claw (A) on the bottom of the No. 2 connector holder.

Text in Illustration
V113147

Lift Up


b.

Lift the No. 2 connector holder and attach the 2 claws (B).

HINT:

After attaching the 2 claws (B), make sure that the claw (A) is securely locked.



c.

Tighten the bolt used to install the connector to the No. 2 connector holder.

HINT:

Tighten the bolt until it turns freely.



d.

Install the wire harness clamp to the brake pedal support assembly.


Hide 55432D 6.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 55606 7.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).