1.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
Install the brake pedal support assembly with the 4 nuts.
Install the brake pedal support reinforcement set bolt.
Tighten the hexagon bolt.
Hold the bolt in place and tighten the nut.
47264A
2.INSTALL PUSH ROD PIN
Apply a light coat lithium soap base glycol grease to the inner surface of the hole on the brake pedal lever.
Set the master cylinder push rod clevis in place, insert the push rod pin from the outside of the vehicle and then install a new clip.
84340
3.INSTALL STOP LIGHT SWITCH ASSEMBLY
Install the stop light switch (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>INSTALLATION).
Connect the stop light switch connector.
82666A
4.INSTALL NO. 2 CONNECTOR HOLDER
Attach the claw (A) on the bottom of the No. 2 connector holder.
|
Lift Up |
Lift the No. 2 connector holder and attach the 2 claws (B).
After attaching the 2 claws (B), make sure that the claw (A) is securely locked.
Install the connector to the No. 2 connector holder.
Install the wire harness clamp to the brake pedal support assembly.
73900
5.INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
55432D
6.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
55606
7.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62111C
8.INSTALL COWL SIDE TRIM BOARD RH
67913B
9.INSTALL FRONT DOOR SCUFF PLATE RH
10.WARM UP CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
11.CHECK BRAKE PEDAL HEIGHT
12.CHECK PEDAL FREE PLAY
13.CHECK PEDAL RESERVE DISTANCE