1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION),
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67913B
3.REMOVE FRONT DOOR SCUFF PLATE RH
62111C
4.REMOVE COWL SIDE TRIM BOARD RH
55606
5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55432D
6.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
73900
7.REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
82666A
8.REMOVE NO. 2 CONNECTOR HOLDER
Disconnect the connector from the No. 2 connector holder.
|
Remove in this Direction |
Disconnect the wire harness clamp from the brake pedal support assembly.
|
Pull Towards You |
Detach the 2 claws (A) of the No. 2 connector holder.
Unlock the claw (B), and then pull the No. 2 connector holder towards you to remove it.
47264A
9.REMOVE PUSH ROD PIN
Remove the clip and push rod pin from the brake pedal lever.
84340
10.REMOVE STOP LIGHT SWITCH ASSEMBLY
Disconnect the stop light switch connector.
Remove the stop light switch (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>REMOVAL).
11.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
Loosen the hexagon bolt.
Hold the bolt in place and loosen the nut.
Only loosen the nut. Do not remove the bolt or nut.
Remove the bolt from the brake pedal support reinforcement.
Remove the 4 nuts and brake pedal support assembly.