Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1VD-FTV) › from 2015.08
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255446 VANE PUMP(for 1VD-FTV) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1VD-FTV)  INSTALLATION  


PROCEDURE

Hide 44310 1.INSTALL VANE PUMP ASSEMBLY (w/ Variable Flow Control Solenoid Valve)

a.

Coat a new O-ring with MP grease and install it to the vane pump.


b.

Install the vane pump with the 2 nuts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 44310 2.INSTALL VANE PUMP ASSEMBLY (w/o Variable Flow Control Solenoid Valve)

a.

Coat a new O-ring with power steering fluid and install it to the vane pump.


b.

Install the vane pump with the 2 nuts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 44410 3.CONNECT PRESSURE FEED TUBE ASSEMBLY (w/ Variable Flow Control Solenoid Valve)

a.

Install a new gasket to the pressure feed tube.


b.

Install the pressure feed tube and union with the union bolt.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:

Make sure that the stopper of the tube touches the vane pump body before tightening the bolt.



c.

Connect the 2 connectors.


Hide 44410 4.CONNECT PRESSURE FEED TUBE ASSEMBLY (w/o Variable Flow Control Solenoid Valve)

a.

Install a new gasket to the pressure feed tube.


b.

Install the pressure feed tube and union with the union bolt.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:

Make sure that the stopper of the tube touches the vane pump body before tightening the bolt.



c.

Connect the connector.


Hide 44348A 5.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.

Connect the pump hose to the vane pump with the clip.


Hide 7.INSTALL NO. 3 IDLER PULLEY (w/ Viscous Heater)

Hide 8.INSTALL NO. 1 IDLER PULLEY (w/ Viscous Heater)

Hide 16470 10.INSTALL RADIATOR RESERVE TANK ASSEMBLY

Hide 17881 12.TEMPORARILY TIGHTEN NO. 1 AIR CLEANER HOSE

Hide 12601E 14.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 53292A 15.INSTALL UPPER RADIATOR SUPPORT SEAL

Hide 53782 16.INSTALL FRONT FENDER APRON TRIM PACKING A

Hide 17.ADD POWER STEERING FLUID

Hide 18.BLEED POWER STEERING FLUID

Hide 19.INSPECT FOR POWER STEERING FLUID LEAK

Hide 20.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).