Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › from 2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM J

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  VGRS System Suspends right after Engine Start  


CAUTION / NOTICE / HINT

NOTICE:

When replacing the steering actuator assembly, perform actuator angle neutral point calibration and initialization after replacement (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

2.CUSTOMER PROBLEM ANALYSIS

B

2.CUSTOMER PROBLEM ANALYSIS
a.

Confirm the conditions present when the VGRS temporarily stopped.

Result
Result Proceed to
The system temporarily stopped during normal driving. A
The system temporarily stopped under harsh conditions such as when turning the steering wheel while the vehicle is stopped. B

HINT:

When the steering torque is large, the actuator easily overheats. In this situation, the system is stopped to prevent the actuator from overheating.




A

3.CHECK STEERING EFFORT

B

5.CHECK VGRS SYSTEM
3.CHECK STEERING EFFORT
a.

Check the steering torque when the steering wheel is turned with the vehicle stopped (for 1VD-FTV: See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 1VD-FTV)>ON-VEHICLE INSPECTION, for 1UR-FE: See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 1UR-FE)>ON-VEHICLE INSPECTION, for 3UR-FE: See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 3UR-FE)>ON-VEHICLE INSPECTION).

OK:

The steering torque is normal.


HINT:

When the power steering system has failed, the system is stopped to protect the system when the load torque is large.


Result
Result Proceed to
OK A
NG (w/ Variable Flow Control Solenoid Valve) B
NG (w/o Variable Flow Control Solenoid Valve) C



A

4.CUSTOMER PROBLEM ANALYSIS

B

C

GO TO POWER STEERING SYSTEM (PROBLEM SYMPTOMS TABLE)

4.CUSTOMER PROBLEM ANALYSIS
a.

Check if the system stops repeatedly when steering the vehicle.

OK:

The system does not stop repeatedly.


HINT:

After the engine switch is turned on (IG) and the steering wheel is operated, an initial check of the lock is performed. When operating the steering wheel during the initial check, VGRS operation may be stopped, but operation is resumed again quickly.




OK

END

NG

REPLACE STEERING ACTUATOR ASSEMBLY

5.CHECK VGRS SYSTEM
a.

Operate the steering wheel and check that the system recovers.

Result
Result Proceed to
The system recovers when the steering wheel is operated. A
The system recovers when the steering wheel is not operated. B



OK

END

NG

REPLACE STEERING ACTUATOR ASSEMBLY