Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › from 2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM C

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  C1592/52  Actuator Neutral Position Calibration Incomplete  


DESCRIPTION

The VGRS ECU (steering control ECU) first checks the actuator angle neutral point calibration flag after entering test mode. If the ECU detects that steering actuator angle neutral point calibration is incomplete twice, it stores DTC C1592/52.

DTC No. DTC Detection Condition Trouble Area
C1592/52 The VGRS ECU (steering control ECU) detects that steering actuator angle neutral point calibration is incomplete twice.
·

Steering actuator assembly

·

VGRS ECU (steering control ECU)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the VGRS ECU (steering control ECU) or steering actuator assembly, perform actuator angle neutral point calibration and initialization after replacing parts (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CLEAR DTC

NEXT

2.PERFORM VGRS SYSTEM CALIBRATION
2.PERFORM VGRS SYSTEM CALIBRATION

NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Check the DTCs (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC C15B2/72 is output (for LHD) B
DTC C15B2/72 is output (for RHD) C
DTC C1592/52 is output after VGRS system calibration has been performed 3 times or more D

NOTICE:

If DTC C1592/52 is output even though the VGRS system calibration has been performed, confirm the procedure again, and perform VGRS system calibration 3 times or more.




A

END

B

REPLACE VGRS ECU (STEERING CONTROL ECU)

C

REPLACE VGRS ECU (STEERING CONTROL ECU)

D

REPLACE STEERING ACTUATOR ASSEMBLY