Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › 2014.08–2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM C

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  C15B4/71  ECU Malfunction  


DESCRIPTION

If the steering control ECU detects an internal malfunction, it will turn the master warning light on, store DTC C15B4/71, and stop VGRS operation.

DTC Code DTC Detection Condition Trouble Area
C15B4/71 The steering control ECU detects an internal malfunction. Steering control ECU

PROCEDURE

1.CHECK MASTER WARNING LIGHT
a.

Check the conditions under which the master warning light comes on.

Result
Result Proceed to
The engine stalled, battery voltage is too low, or the steering control ECU connector is disconnected. A
Conditions other than above (for LHD). B
Conditions other than above (for RHD). C



A

2.CLEAR DTC

B

C

2.CLEAR DTC

NEXT

3.PERFORM VGRS SYSTEM CALIBRATION
3.PERFORM VGRS SYSTEM CALIBRATION

NEXT

4.CHECK DTC
4.CHECK DTC
a.

Check for DTCs (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
C15B4/71 is output (for LHD) B
C15B4/71 is output (for RHD) C



A

B

C