Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) › from 2015.08
RM2660E _55 Steering _052826 STEERING COLUMN _0255455 STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column) G

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


Hide 5.INSPECT TELESCOPIC MOTOR

a.

Inspect the tilt motor:

i.

Disconnect the tilt motor connector.


ii.
U117407E01
0.305,0.226 0.508,0.414 0.204,0.188 10 *a 2.069,1.112 2.386,0.666 false 2.069,1.112 2.386,0.666 false 0.587,0.555 0.935,0.740 0.348,0.185 10 TIM- 1.358,1.131 1.042,0.686 false 1.358,1.131 1.042,0.686 false 2.44,0.555 2.788,0.740 0.348,0.185 10 TIM+

Apply 12 V battery voltage to the tilt motor connector. Then check the steering wheel tilt operation.

OK
Measurement Condition Specified Condition
12 V battery positive (+) lead → Terminal 1 (TIM+)
12 V battery negative (-) lead → Terminal 2 (TIM-)
The steering wheel tilts up.
12 V battery negative (-) lead → Terminal 1 (TIM+)
12 V battery positive (+) lead → Terminal 2 (TIM-)
The steering wheel tilts down.

If the result is not as specified, replace the steering column assembly.



b.

Inspect the telescopic motor:

i.

Disconnect the telescopic motor connector.


ii.
U117406E01
0.305,0.226 0.508,0.414 0.204,0.188 10 *a 2.069,1.112 2.386,0.666 false 2.069,1.112 2.386,0.666 false 2.439,0.555 2.899,0.740 0.459,0.185 10 TEM- 1.358,1.131 1.042,0.686 false 1.358,1.131 1.042,0.686 false 0.548,0.587 1.035,0.772 0.487,0.185 10 TEM+

Apply 12 V battery voltage to the telescopic motor connector. Then check the steering column telescopic operation.

OK
Measurement Condition Specified Condition
12 V battery positive (+) lead → Terminal 2 (TEM+)
12 V battery negative (-) lead → Terminal 1 (TEM-)
The steering column contracts.
12 V battery positive (+) lead → Terminal 1 (TEM-)
12 V battery negative (-) lead → Terminal 2 (TEM+)
The steering column extends.

If the result is not as specified, replace the steering column assembly.