Home › Audio / Visual / Telematics › AUDIO / VIDEO › MULTI-MEDIA INTERFACE ECU › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255485 MULTI-MEDIA INTERFACE ECU A

AUDIO / VIDEO  MULTI-MEDIA INTERFACE ECU  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 861A2 1.INSTALL NO. 1 MULTI-MEDIA INTERFACE BRACKET

a.

Install the bracket with the 2 bolts.


Hide 861A3 2.INSTALL NO. 2 MULTI-MEDIA INTERFACE BRACKET

a.

Install the bracket with the 2 bolts.


Hide 861A1 3.INSTALL MULTI-MEDIA INTERFACE ECU

a.

Install the multi-media interface ECU with the 2 bolts.


b.

Connect the connectors.


Hide 58510D 4.INSTALL FRONT FLOOR CARPET ASSEMBLY

a.

Install the carpet that was pulled back to remove the selector. For further details, refer to the installation procedure (See page Audio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>INSTALLATION).


Hide 55317A 7.INSTALL INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)

Hide 8.INSTALL INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)

Hide 9.INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)

a.

Install the front seat assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>INSTALLATION).


Hide 10.INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)

a.

Install the front seat assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>INSTALLATION).


Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 12.CHECK SRS WARNING LIGHT

a.

Check the SRS warning light (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).