| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15C3 | A short is detected in the speaker output circuit. | ·
Radio and Display Receiver Assembly*1 ·
Stereo component amplifier assembly*2 ·
Speakers ·
Harness or connector |
*1: for 6 Speakers
*2: for 9 Speakers
After the inspection is completed, clear the DTCs.
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
NEXT
Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR).
DTC B15C3 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Check the vehicle condition.
| Result | Proceed to |
|---|---|
| for 6 Speakers | A |
| for 9 Speakers | B |
A
B
*1: for RH Side
*2: for LH Side
Disconnect the F122 and F120 radio and display receiver assembly connectors.
Disconnect the F13*1 and/or F14*2 front No. 1 speaker assembly connector.
Disconnect the F7*1 and/or F8*2 front No. 2 speaker assembly connector.
Disconnect the J18*1 and/or J19*2 rear speaker set connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F120-1 (FR+) - F7-1 (+) | Always | Below 1 Ω |
| F120-5 (FR-) - F7-3 (-) | Always | Below 1 Ω |
| F7-2 (TWR+) - F13-1 | Always | Below 1 Ω |
| F7-4 (TWR-) - F13-2 | Always | Below 1 Ω |
| F122-1 (RR+) - J18-1 | Always | Below 1 Ω |
| F122-3 (RR-) - J18-2 | Always | Below 1 Ω |
| F120-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| F120-5 (FR-) - Body ground | Always | 10 kΩ or higher |
| F7-2 (TWR+) - Body ground | Always | 10 kΩ or higher |
| F7-4 (TWR-) - Body ground | Always | 10 kΩ or higher |
| F122-1 (RR+) - Body ground | Always | 10 kΩ or higher |
| F122-3 (RR-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F120-2 (FL+) - F8-1 (+) | Always | Below 1 Ω |
| F120-6 (FL-) - F8-3 (-) | Always | Below 1 Ω |
| F8-2 (TWL+) - F14-1 | Always | Below 1 Ω |
| F8-4 (TWL-) - F14-2 | Always | Below 1 Ω |
| F122-2 (RL+) - J19-1 | Always | Below 1 Ω |
| F122-6 (RL-) - J19-2 | Always | Below 1 Ω |
| F120-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| F120-6 (FL-) - Body ground | Always | 10 kΩ or higher |
| F8-2 (TWL+) - Body ground | Always | 10 kΩ or higher |
| F8-4 (TWL-) - Body ground | Always | 10 kΩ or higher |
| F122-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| F122-6 (RL-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the front No. 1 speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL).
Inspect the front No. 1 speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION).
OK
NG
Replace the front No. 2 speaker with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL).
Check that the malfunction disappears.
Connect all the connectors that were disconnected from the front No. 2 speaker assemblies.
When there is a possibility that either the right or left front speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both LH and RH sides.
Malfunction disappears.
OK
NG
Remove the rear speaker set (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL).
Inspect the rear speaker set (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION).
| Result | Proceed to |
|---|---|
| OK | A |
| NG | B |
A
B
*1: for RH Side
*2: for LH Side
Disconnect the F74 stereo component amplifier assembly connector.
Disconnect the I1*1 and/or I10*2 front No. 1 speaker assembly connector.
Disconnect the F7*1 and/or F8*2 front No. 2 speaker assembly connector.
Disconnect the F13*1 and/or F14*2 front No. 3 speaker assembly connector.
Disconnect the F6 front No. 4 speaker assembly connector.
Disconnect the J18*1 and/or J19*2 rear speaker set connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F74-7 (CTR+) - F6-1 | Always | Below 1 Ω |
| F74-22 (CTR-) - F6-2 | Always | Below 1 Ω |
| F74-7 (CTR+) - Body ground | Always | 10 kΩ or higher |
| F74-22 (CTR-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F74-5 (WFR+) - I1-1 | Always | Below 1 Ω |
| F74-20 (WFR-) - I1-2 | Always | Below 1 Ω |
| F74-13 (FR+) - F7-1 (+) | Always | Below 1 Ω |
| F74-28 (FR-) - F7-3 (-) | Always | Below 1 Ω |
| F7-2 (TWR+) - F13-1 | Always | Below 1 Ω |
| F7-4 (TWR-) - F13-2 | Always | Below 1 Ω |
| F74-15 (RR+) - J18-1 | Always | Below 1 Ω |
| F74-30 (RR-) - J18-2 | Always | Below 1 Ω |
| F74-5 (WFR+) - Body ground | Always | 10 kΩ or higher |
| F74-20 (WFR-) - Body ground | Always | 10 kΩ or higher |
| F74-13 (FR+) - Body ground | Always | 10 kΩ or higher |
| F74-28 (FR-) - Body ground | Always | 10 kΩ or higher |
| F7-2 (TWR+) - Body ground | Always | 10 kΩ or higher |
| F7-4 (TWR-) - Body ground | Always | 10 kΩ or higher |
| F74-15 (RR+) - Body ground | Always | 10 kΩ or higher |
| F74-30 (RR-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F74-4 (WFL+) - I10-1 | Always | Below 1 Ω |
| F74-19 (WFL-) - I10-2 | Always | Below 1 Ω |
| F74-12 (FL+) - F8-1 (+) | Always | Below 1 Ω |
| F74-27 (FL-) - F8-3 (-) | Always | Below 1 Ω |
| F8-2 (TWL+) - F14-2 | Always | Below 1 Ω |
| F8-4 (TWL-) - F14-1 | Always | Below 1 Ω |
| F74-14 (RL+) - J19-1 | Always | Below 1 Ω |
| F74-29 (RL-) - J19-2 | Always | Below 1 Ω |
| F74-4 (WFL+) - Body ground | Always | 10 kΩ or higher |
| F74-19 (WFL-) - Body ground | Always | 10 kΩ or higher |
| F74-12 (FL+) - Body ground | Always | 10 kΩ or higher |
| F74-27 (FL-) - Body ground | Always | 10 kΩ or higher |
| F8-2 (TWL+) - Body ground | Always | 10 kΩ or higher |
| F8-4 (TWL-) - Body ground | Always | 10 kΩ or higher |
| F74-14 (RL+) - Body ground | Always | 10 kΩ or higher |
| F74-29 (RL-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the front No. 1 speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL).
Inspect the front No. 1 speaker assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION).
OK
NG
Replace the front No. 2 speaker with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL).
Check that the malfunction disappears.
Connect all the connectors that were disconnected from the front No. 2 speaker assemblies.
When there is a possibility that either the right or left front speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both LH and RH sides.
Malfunction disappears.
OK
NG
Replace the front No. 4 speaker with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL).
Check that the malfunction disappears.
Connect all the connectors that were disconnected from the front No. 4 speaker assemblies.
Malfunction disappears.
OK
NG
Replace the front No. 3 speaker with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>PILLAR SPEAKER (for Front Side)>REMOVAL).
Check that the malfunction disappears.
Connect all the connectors that were disconnected from the front No. 3 speaker assemblies.
When there is a possibility that either the right or left front speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both LH and RH sides.
Malfunction disappears.
OK
NG
Remove the rear speaker set (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL).
Inspect the rear speaker set (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION).
| Result | Proceed to |
|---|---|
| OK | A |
| NG | B |
A
B