CHECK MAIN BODY ECU
| *1 | Cowl Side Junction Block LH | - | - |
| *1 | Main Body ECU | - | - |
Remove the main body ECU from the cowl side junction block LH.
Connect the cowl side junction block LH connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| A-11 (GND1) - Body ground | None - Body ground | Ground | Always | Below 1 Ω |
| A-30 (ACC) - Body ground | None - Body ground | ACC power supply | Engine switch on (ACC) | 11 to 14 V |
| Engine switch off | Below 1 V | |||
| A-31 (BECU) - Body ground | None - Body ground | Battery power supply | Always | 11 to 14 V |
| A-32 (IG) - Body ground | None - Body ground | IG power supply | Engine switch on (IG) | 11 to 14 V |
| Engine switch off | Below 1 V |
Install the main body ECU to the cowl side junction block LH.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 2I-7 (GSW) - Body ground | B - Body ground | Airbag sensor signal
(collision detection signal) |
Engine switch on (IG) with airbag sensor assembly connector disconnected | 2.8 to 4.3 V |
| 2I-9 (ACTD) - Body ground | LA-L - Body ground | Door lock motor unlock drive output signal (driver door) | Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder off | Below 1 V |
| Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder unlocked | 11 to 14 V | |||
| 2J-3 (ACT-) - Body ground | LA-L - Body ground | Door lock motor unlock drive output signal (front passenger side door and rear door RH) | Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder off | Below 1 V |
| Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder unlocked | 11 to 14 V | |||
| 2J-4 (ACT-) - Body ground | LA-V - Body ground | Door lock motor unlock drive output signal (rear door RH) | Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder off | Below 1 V |
| Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder unlocked | 11 to 14 V | |||
| 2J-5 (ACT+) - Body ground | LA-B - Body ground*3
LA-R - Body ground*4 |
Door lock motor lock drive output signal (front passenger side door) | Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder off | Below 1 V |
| Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder locked | 11 to 14 V | |||
| 2J-6 (ACT+) - Body ground | LA-R - Body ground | Door lock motor lock drive output signal (driver door) | Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder off | Below 1 V |
| Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder locked | 11 to 14 V | |||
| 2J-7 (ACT+) - Body ground | LA-GR - Body ground | Door lock motor lock drive output signal (rear door RH) | Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder off | Below 1 V |
| Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder locked | 11 to 14 V | |||
| 2J-16 (LSFR) - Body ground | B - Body ground | Front door RH unlock detection switch input signal | Front door RH unlocked | Below 1 V |
| ignition switch off, all doors closed and front door RH locked | Pulse generation | |||
| 2J-19 (LSFL) - Body ground | G - Body ground | Front door LH unlock detection switch input signal | Front door LH unlocked | Below 1 V |
| ignition switch off, all doors closed and front door LH locked | Pulse generation | |||
| 2J-21 (UL1) - Body ground | LG - Body ground | Door control switch assembly input | Door control switch assembly off | Pulse generation |
| Door control switch assembly on (unlock) | Below 1 V | |||
| 2J-21 (UL1) - Body ground
*1 |
LG - Body ground | Master switch (door control switch) input | Master switch (door control switch) off | Pulse generation |
| Master switch (door control switch) on (unlock) | Below 1 V | |||
| 2J-26 (L1) - Body ground | L - Body ground | Door control switch assembly input | Door control switch assembly off | Pulse generation |
| Door control switch assembly on (lock) | Below 1 V | |||
| 2J-26 (L1) - Body ground
*1 |
L - Body ground | Master switch (door control switch) input | Master switch (door control switch) off | Pulse generation |
| Master switch (door control switch) on (lock) | Below 1 V | |||
| 2J-28 (KSW) - Body ground*2 | G - Body ground | Key unlock warning switch input | No key in ignition key cylinder | Pulse generation |
| Key in ignition key cylinder | Below 1 V | |||
| 2J-29 (RCTY) - Body ground | BE - Body ground | Rear door courtesy light switch assembly RH input signal | Rear door RH open | Below 1 V |
| Rear door RH closed | Pulse generation | |||
| 2K-7 (ACT+) - Body ground | LA-SB - Body ground*5
SB - Body ground*6 |
Door lock motor lock drive output signal (rear door LH) | Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder off | Below 1 V |
| Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder locked | 11 to 14 V | |||
| 2K-8 (TR+) - Body ground*7 | G - Body ground | Back door lock motor drive output | Back door closed | Below 1 V |
| Back door open | 11 to 14 V | |||
| 2K-9 (ACT-) - Body ground | LA-P - Body ground*5
P - Body ground*6 |
Door lock motor unlock drive output signal (rear door LH and back door*6) | Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder off | Below 1 V |
| Multiplex network master switch assembly (door control switch), power window regulator switch assembly (door control switch) or driver door key cylinder unlocked | 11 to 14 V | |||
| 2K-31 (BCTY) - Body ground*5, *7 | W - Body ground | Back door courtesy light switch input | Back door closed | Below 1 V |
| Back door open | Pulse generation | |||
| 2K-33 (LSWL) - Body ground | L - Body ground | Rear door LH unlock detection switch input signal | Rear door LH unlocked | Below 1 V |
| ignition switch off, all doors closed and rear door LH locked | Pulse generation | |||
| 2K-34 (LCTY) - Body ground | BE - Body ground | Rear door courtesy light switch assembly LH input signal | Rear door LH open | Below 1 V |
| Rear door LH closed | Pulse generation | |||
| E117-2 (LSWR) - Body ground | W - Body ground | Rear door RH unlock detection switch input signal | Rear door RH unlocked | Below 1 V |
| ignition switch off, all doors closed and rear door RH locked | 11 to 14 V | |||
| E117-3 (ACTG) - Body ground*5 | B - Body ground | Collision door lock release signal | Collision door lock release function does not operate | Below 2 V*8
7.3 to 9.9 V*9 |
| Collision door lock release function operates | Below 1 V | |||
| E118-2 (UL3) - Body ground | P - Body ground | Driver door key-linked unlock input | Driver door key cylinder turned to neutral position | Pulse generation |
| Driver door key cylinder turned to on (unlock) | Below 1 V | |||
| E118-6 (FLCY) - Body ground | V - Body ground | Front door courtesy light switch assembly LH input signal | Front door LH open | Below 1 V |
| Front door LH closed | Pulse generation | |||
| E118-17 (LSWB) - Body ground*6 | B - Body ground | Back door unlock detection switch input signal | Back door unlocked | Below 1 V |
| ignition switch off, all doors closed and back door locked | 11 to 14 V | |||
| E118-27 (FRCY) - Body ground | V - Body ground | Front door courtesy light switch assembly RH input signal | Front door RH open | Below 1 V |
| Front door RH closed | Pulse generation | |||
| E118-29 (L2) - Body ground | G - Body ground | Driver door key-linked unlock input | Driver door key cylinder turned to neutral position | Pulse generation |
| Driver door key cylinder turned to on (lock) | Below 1 V |
*1: for Models with Jam Protection Function on Driver Door Window Only
*2: w/o Entry and Start System
*3: for China
*4: except China
*5: for Lift Gate Type
*6: for Double Swing Out Type
*7: w/o Power Back Door System
*8: Door control battery not charged
*9: Door control battery charging or charged
If the result is not as specified, the ECU may have a malfunction.
CHECK DOUBLE LOCK DOOR CONTROL RELAY (w/ Double Locking Function)
Disconnect the E167 double lock door control relay connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| E167-12 (+B) - E167-7 (GND) | LA-W - W-B | Battery power supply | Always | 11 to 14 V |
| E167-11 (CPUB) - E167-17 (GND) | G - W-B | ECU power supply | Always | 11 to 14 V |
| E167-7 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 V |
If the result is not as specified, there may be a malfunction on the wire harness side.
Reconnect the E86 double lock door control relay connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| E167-1 (ACTR) - E167-7 (GND) | P - V | All door double lock motor off signal | Door lock set → unset | Below 1 V → 11 to 14 V → Below 1 V |
| E167-8 (ACTS) - E167-7 (GND) | G - W-B | All door double lock motor on signal | Door lock unset → set | Below 1 V → 11 to 14 V → Below 1 V |
| E167-6 (DLPD) - E167-7 (GND) | LG - Body ground | Double lock position switch signal | Double lock set | Below 1 Ω |
| Double lock unset | 10 kΩ or higher | |||
| E167-5 (DLPP) - E167-7 (GND) | GR - W-B | Double lock position switch signal | Double lock set | Below 1 Ω |
| Double lock unset | 10 kΩ or higher | |||
| E167-3 (DLPR) - E167-7 (GND) | SB - W-B | Double lock position switch signal | Double lock set | Below 1 Ω |
| Double lock unset | 10 kΩ or higher | |||
| E167-3 (DLPL) - E167-7 (GND) | LG - W-B | Double lock position switch signal | Double lock set | Below 1 Ω |
| Double lock unset | 10 kΩ or higher |
If the result is not as specified, the ECU may have a malfunction.