89221
1.INSTALL MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
Make sure that no foreign matter gets on the connecting surfaces.
Do not touch the ECU connector.
Insert the main body ECU (multiplex network body ECU) up to the position where it contacts the housing sidewall of the guide as shown in the illustration.
| *a | 20° |
|
Housing Sidewall |
Make sure to keep the angle 20° or more as shown in the illustration.
Slide the main body ECU (multiplex network body ECU) along the housing sidewall so that it attaches to the 2 guides.
|
Housing Sidewall |
While keeping the main body ECU (multiplex network body ECU) in contact with side A of the junction block (axis of rotation), rotate it downward as shown in the illustration.
| *a | Side A Contact Portion |
Press the push area until the claw engages to install the main body ECU (multiplex network body ECU).
|
Push Area |
Make sure to press only the push area.
Confirm the engagement of the main body ECU (multiplex network body ECU) and junction block by listening for the lock sound.
If a lock sound cannot be heard, visually check the lock part engagement. The engagement can also be confirmed if the main body ECU (multiplex network body ECU) and junction block are flush.
82673A
2.INSTALL JUNCTION BLOCK BRACKET
Attach the guide to install the junction block bracket.
Install the bolt.
89960
3.INSTALL HEADLIGHT LEVELING ECU ASSEMBLY (w/ Automatic Headlight Beam Level Control System, for Static Headlight Auto Leveling)
89940
4.INSTALL HEADLIGHT SWIVEL ECU ASSEMBLY (w/ Automatic Headlight Beam Level Control System, for Dynamic Headlight Auto Leveling)
5.INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
Connect the back side of the instrument panel junction block assembly 2 connectors with lock lever.
Be sure to connect each connector securely.
Connect the connector and push the lock lever to attach the claw.
Slide the connector lock to attach the claw.
Connect the connector and push the lock lever to attach the claw.
Install the instrument panel junction block assembly with the bolt and screw.
Connect each connector.
| *A | w/ Automatic Headlight Beam Level Control System |
Connect the connector with lock lever.
| *a | Connector with Lock Lever |
Use the same procedure to connect the connector with lock lever on the other side.
Connect the connector.
Push the lock lever to attach the claw.
85940
6.INSTALL WINDSHIELD WIPER RELAY ASSEMBLY
55433B
7.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
55443D
8.INSTALL INSTRUMENT PANEL BOX DOOR KNOB
55476A
9.INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55312
10.INSTALL LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)
73990
11.INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)
62112
12.INSTALL COWL SIDE TRIM BOARD LH
55607
13.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Cover)
67914B
14.INSTALL FRONT DOOR SCUFF PLATE LH
55318C
15.INSTALL INSTRUMENT SIDE PANEL LH
55403C
16.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
55449C
17.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
18.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
19.CHECK SRS WARNING LIGHT