Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM(w/o Entry and Start System) › from 2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255575 THEFT DETERRENT SYSTEM(w/o Entry and Start System) J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM(w/o Entry and Start System)  Engine Hood Courtesy Switch Circuit  


DESCRIPTION

The engine hood courtesy switch is installed together with the hood lock. This switch turns on when the engine hood is closed and turns off when the engine hood is opened.

WIRING DIAGRAM

B341516E08
5.156,2.625 5.667,2.802 0.51,0.177 10 false E118 4.938,0.906 5.094,1.104 0.156,0.198 10 false 11 5.188,0.99 6.052,1.167 0.865,0.177 10 false HCTY 2.396,1.344 3.073,1.5 0.677,0.156 10 false A74 5.156,2.792 6.833,3.156 1.677,0.365 10 false Main Body ECU (Multiplex Network Body ECU) 2.208,0.865 2.781,1.25 0.573,0.385 10 false 1 3.115,0.854 3.51,1.104 0.396,0.25 10 false 2 2.354,1.521 4.198,2.104 1.844,0.583 10 false Hood Lock Assembly (Engine Hood Courtesy Switch)

CAUTION / NOTICE / HINT

NOTICE:
·

If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.

·

w/ Door Control Battery:

As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), first perform the inspections in On-Vehicle Inspection to confirm that there are no malfunctions in the power source circuit for the main body ECU (multiplex network body ECU) before performing this troubleshooting procedure (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PRECAUTION).



PROCEDURE

1.READ VALUE USING GTS (HOOD COURTESY SW)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

According to the display on the GTS, read the Data List.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Hood Courtesy SW Engine hood courtesy switch/ON or OFF ON: Engine hood closed
OFF: Engine hood open
-

OK:

The indicator on the GTS switches between ON and OFF in accordance with the engine hood courtesy switch (hood lock assembly) status.




OK

NG

2.CHECK HARNESS AND CONNECTOR (HOOD LOCK ASSEMBLY [ENGINE HOOD COURTESY SWITCH]- MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] AND BODY GROUND)
2.CHECK HARNESS AND CONNECTOR (HOOD LOCK ASSEMBLY [ENGINE HOOD COURTESY SWITCH]- MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] AND BODY GROUND)
a.

Disconnect the A74 engine hood courtesy switch (hood lock assembly) connector.


b.

Disconnect the E118 main body ECU (multiplex network body ECU) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A74-2 (+) - E118-11(HCTY) Always Below 1 Ω
A74-1 (E) - Body ground Always Below 1 Ω
A74-2 (+) - Body ground Always 10 kΩ or higher
E118-11 (HCTY) - Body ground Always 10 kΩ or higher




OK

3.INSPECT ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)

b.

Inspect the hood lock assembly (engine hood courtesy switch) (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>INSPECTION).

Result
Result Proceed to
OK (for LHD) A
OK (for RHD) B
NG C



A

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

B

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

C

REPLACE ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)