83100
1.INSTALL COMBINATION METER ASSEMBLY
Connect the connectors.
Install the combination meter with the 4 screws.
55404C
2.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Attach the 9 claws to install the finish panel.
Attach the 4 claws.
55475A
3.INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55403C
4.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
w/ Entry and Start System:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Cool Box)>INSTALLATION)
w/o Entry and Start System:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Console Box Lid)>INSTALLATION)
55449C
5.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55474C
6.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter (See page General>INTRODUCTION>REPAIR INSTRUCTION>CUSTOMIZE PARAMETERS).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).