Home › Vehicle Interior › PRE-CRASH SAFETY › SEAT BELT CONTROL ECU(for LHD) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052844 PRE-CRASH SAFETY _0255619 SEAT BELT CONTROL ECU(for LHD) A

PRE-CRASH SAFETY  SEAT BELT CONTROL ECU(for LHD)  INSTALLATION  


PROCEDURE

Hide 89815 1.INSTALL SEAT BELT CONTROL ECU

E155217

a.

Install the seat belt control ECU to the certification ECU with the bolt.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.
E155216

Install the seat belt control ECU together with the certification ECU with the 2 nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


c.

Connect the 2 connectors.


Hide 55432D 2.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 73900 4.INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 55303B 5.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

Hide 55606 6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 55475A 7.INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55474C 8.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55403C 9.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Hide 55449C 10.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Driver Side Knee Airbag)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 12.CHECK SRS WARNING LIGHT (w/ Driver Side Knee Airbag)