The seat belt control ECU receives information from the master cylinder solenoid (skid control ECU) via the CAN communication line and tightens the seat belt by operating the motor in the front seat outer belt assembly RH or LH.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2001 | ·
Short to ground in seat belt motor RH circuit continues for 1 second or more. ·
Short in seat belt motor RH circuit. |
·
Front seat outer belt assembly RH ·
Harness or connector ·
Seat belt control ECU |
| B2006 | ·
Short to ground in seat belt motor LH circuit continues for 1 second or more. ·
Short in seat belt motor LH circuit. |
·
Front seat outer belt assembly LH ·
Harness or connector ·
Seat belt control ECU |
The pretensioner is built into the front seat outer belt assembly. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may deploy the pretensioner.
Disconnect the E41 seat belt control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E41-3 (MOL+) - Body ground | Always | 1 MΩ or higher |
| E41-4 (MOL-) - Body ground |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E41-1 (MOR-) - Body ground | Always | 1 MΩ or higher |
| E41-2 (MOR+) - Body ground |
| Result | Proceed to |
|---|---|
| OK
(for LHD) |
A |
| OK
(for RHD) |
B |
| NG | C |
A
B
C
Disconnect the E41 seat belt control ECU connector.
Disconnect the K11*1 or L5*2 front seat outer belt connector.
*1: for LH
*2: for RH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K11-1 (MOL+) - Body ground | Always | 1 MΩ or higher |
| K11-2 (MOL-) - Body ground |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L5-1 (MOR+) - Body ground | Always | 1 MΩ or higher |
| L5-2 (MOR-) - Body ground |
| Result | Proceed to |
|---|---|
| OK
(for DTC B2001) |
A |
| OK
(for DTC B2006) |
B |
| NG | C |
A
B
C