This DTC is stored when the beam axis of the millimeter wave radar sensor is not aligned with the direction the vehicle is traveling. If the beam axis adjustment is not performed after installing a new millimeter wave radar sensor, the pre-crash safety system DTC B2056 is output, and when the vehicle speed is 40 km/h (25 mph) or more, the dynamic radar cruise control system DTC P1572 is output.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2056 | The engine switch is on (IG) and the beam axis of the millimeter wave radar sensor is determined to be misaligned. | ·
Millimeter wave radar sensor ·
Seat belt control ECU ·
Distance control ECU |
Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.
Clear the DTC (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 40 km/h (25 mph) or more.
Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC P1572 is not output.
OK
NG
Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| OK
(DTC B2056 is not output) |
A |
| NG
(for LHD) |
B |
| NG
(for RHD) |
C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C