This DTC is stored when the vehicle is driven at a vehicle speed of 5 km/h (3 mph) or more and a malfunction occurs in the yaw rate sensor.
This circuit consists of the yaw rate sensor and seat belt control ECU.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2057 | The vehicle speed is 5 km/h (3 mph) or more and a malfunction is detected in the yaw rate sensor. | ·
Yaw rate sensor ·
Seat belt control ECU ·
Distance control ECU |
Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Code.
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC C1234 is not output.
OK
NG
Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| OK
(DTC B2057 is not output) |
A |
| NG
(for LHD) |
B |
| NG
(for RHD) |
C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C