Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052844 PRE-CRASH SAFETY _0255621 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  B2071  Stop Light Control Relay Malfunction  


DESCRIPTION

This DTC is stored when a malfunction in the stop light operation relay circuit of the vehicle stability control system is detected. This circuit consists of the master cylinder solenoid (skid control ECU) and seat belt control ECU. Signals are sent from the master cylinder solenoid (skid control ECU) via the CAN communication line.

DTC Code DTC Detection Condition Trouble Area
B2071 Malfunction in the brake system is detected.
·

CAN communication system

·

Vehicle stability control system

·

Seat belt control ECU



WIRING DIAGRAM

E149011E02
0.859,2.46 2.828,2.629 1.969,0.170 10 : CAN Communication Line 4.923,1.625 6.341,1.855 1.418,0.230 10 Seat Belt Control ECU 1.082,1.625 2.677,2.110 1.595,0.485 10 Master Cylinder Solenoid (Skid Control ECU) 4.965,0.565 5.399,0.795 0.434,0.230 10 CANH 4.965,1.071 5.399,1.301 0.434,0.230 10 CANL 2.078,0.565 2.512,0.795 0.434,0.230 10 CANH 2.078,1.071 2.512,1.301 0.434,0.230 10 CANL

PROCEDURE

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
a.

Use the intelligent tester to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>HOW TO PROCEED WITH TROUBLESHOOTING for LHD, Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>HOW TO PROCEED WITH TROUBLESHOOTING for RHD).

Result
Result Proceed to
OK
(DTC U0122 is not output)
A
NG
(for LHD)
B
NG
(for RHD)
C

HINT:

DTC U0122: Lost Communication with Skid Control ECU




A

2.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)

B

C

2.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Code.



c.

Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).

OK:

DTC C1380 is not output.


HINT:

DTC C1380: Stop Light Control Relay Malfunction




OK

3.CHECK DTC (PRE-CRASH SAFETY SYSTEM)

NG

GO TO VEHICLE STABILITY CONTROL SYSTEM (DTC C1380)

3.CHECK DTC (PRE-CRASH SAFETY SYSTEM)
a.

Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.



c.

Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
OK
(DTC B2071 is not output)
A
NG
(for LHD)
B
NG
(for RHD)
C



A

B

C