Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255697 CONDENSER A

HEATING / AIR CONDITIONING  CONDENSER  REMOVAL  


PROCEDURE

Hide 53292A 1.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 2.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 3. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 4.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 88711 6.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

E142186

a.

Remove the bolt and disconnect the discharge hose from the cooler condenser.

NOTICE:
·

When removing the bolt, do not allow any tools to contact the pipe.

·

When removing the bolt, hold a part of the pipe near the connector.




b.

Remove O-ring from the discharge hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 88716A 7.DISCONNECT COOLER REFRIGERANT LIQUID PIPE A

E142187

a.

Remove the 2 bolts and disconnect the liquid pipe A from the cooler condenser.

NOTICE:
·

When removing the bolt, do not allow any tools to contact the pipe.

·

When removing the bolt, hold a part of the pipe near the connector.




b.

Remove O-ring from the liquid pipe A.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 86510 8.REMOVE HIGH PITCHED HORN ASSEMBLY

Hide 86520 9.REMOVE LOW PITCHED HORN ASSEMBLY

Hide 88590 10.REMOVE SHROUD BLOWER ASSEMBLY (w/ Rear Air Conditioning System)

Hide 32917 11.REMOVE TRANSMISSION OIL COOLER AIR DUCT (w/ Air Cooled Transmission Oil Cooler)

C167867

a.

Remove the 4 bolts and transmission oil cooler air duct.


Hide 32910 12.REMOVE OIL COOLER ASSEMBLY (w/ Air Cooled Transmission Oil Cooler)

C167868

a.

Remove the 4 bolts and oil cooler.


Hide 53209B 13.REMOVE HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY

E154814

a.

Remove the hood lock nut cap.


b.

Remove the 3 bolts, nut and brace.


Hide 53629 14.REMOVE HOOD LOCK CONTROL CABLE COVER

Hide 53201 16.REMOVE RADIATOR SUPPORT SUB-ASSEMBLY

E154816

a.

Remove the 8 bolts and radiator support.


Hide 88460 17.REMOVE COOLER CONDENSER ASSEMBLY

a.
E154209

Remove the cooler condenser as shown in the illustration.


Hide 88474 18.REMOVE COOLER DRYER

a.
I030086

Using a 14 mm socket hexagon wrench, remove the cap from the modulator.


b.
I032475

Remove O-ring from the cap.


c.
E050386

Using pliers, remove the cooler dryer.