If a door glass or a power window regulator motor assembly does not operate smoothly, the catch protection function may be triggered automatically, resulting in the auto down operation being unable to fully open the window.
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only)>INITIALIZATION).
If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only)>INITIALIZATION).
Initialize the power window regulator motor assembly (applicable location) (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)>INITIALIZATION).
NEXT
Check that each power window moves when the auto up and down function of the multiplex network master switch assembly, power window regulator switch assembly, rear power window regulator switch assembly LH or rear power window regulator switch assembly RH is operated (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)>OPERATION CHECK).
Auto up and down function is normal (applicable location).
OK
NG
Remove the door window regulator.
for Front Door : Vehicle Exterior>DOOR / HATCH>FRONT DOOR>DISASSEMBLY
for Rear Door : Vehicle Exterior>DOOR / HATCH>REAR DOOR>DISASSEMBLY
Install the window glass to the door glass run.
for Front Door : Vehicle Exterior>DOOR / HATCH>FRONT DOOR>REASSEMBLY
for Rear Door : Vehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
Check if the door window regulator operates smoothly.
Check that the window glass slides smoothly when sliding it down by hand.
Perform initialization again (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)>INITIALIZATION).
Ensure the following:
The window glass fits with the glass run without improper contact or deformation.
Foreign matter is not caught in the glass run.
The glass run is not misaligned.
The belt moulding or inner weatherstrip is not caught.
The glass is not tilted and does not catch.
Door window glass slides smoothly.
| Result | Proceed to |
|---|---|
| OK (Driver door power window) | A |
| OK (Front passenger door power window) | B |
| OK (Rear door LH power window) | C |
| OK (Rear door RH power window) | D |
| NG | E |
A
B
C
D
E