Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING ECU (for LHD) › from 2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255818 HEADLIGHT LEVELING ECU(for LHD) A

LIGHTING (EXT)  HEADLIGHT LEVELING ECU(for LHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55448A 3.REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

Hide 55402C 4.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Hide 55607 6.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 62111C 8.REMOVE COWL SIDE TRIM BOARD RH

Hide 55476A 10.REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55443D 11.REMOVE INSTRUMENT PANEL BOX DOOR KNOB

Hide 55433B 12.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 13.REMOVE HEADLIGHT SWIVEL ECU ASSEMBLY

a.
E334084

Disconnect the connector.


b.

Remove the nut and headlight swivel ECU assembly.