Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2017.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255415 VEHICLE STABILITY CONTROL SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  DIAGNOSIS SYSTEM  


DIAGNOSIS


a.

If the skid control ECU (master cylinder solenoid) detects a malfunction, the ABS warning light and/or brake warning light and the slip indicator light come on in accordance with the trouble area to warn the driver.

HINT:

This system has a Test Mode sensor signal check function. The test mode DTCs can be read by connecting the GTS.


NOTICE:

If parts connected to the IG terminal circuit are damaged due to high voltage, DTCs may not be able to be output from the ABS warning light and slip indicator light by connecting SST to the DLC3. In this case, inspect the IG power source circuit.




WARNING LIGHT AND INDICATOR LIGHT CHECK


a.

Check that the ABS warning light, brake warning light and slip indicator light come on when the ignition switch is turned to ON, and go off in approximately 3 seconds.

HINT:
·

If the indicator remains on or does not come on, proceed to troubleshooting for the light circuit below.

·

When the brake fluid level is low, the brake warning light comes on.



HINT:

If the indicator remains on or does not come on, proceed to troubleshooting for the light circuit below.


Trouble Area See Procedure
ABS warning light circuit (Remains on) (Click here)
ABS warning light circuit (Does not come on) (Click here)
Brake warning light circuit (Remains on) (Click here)
Brake warning light circuit (Does not come on) (Click here)
Slip indicator light circuit (Remains on) (Click here)
Slip indicator light circuit (Does not come on) (Click here)