| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | OUTER REAR VIEW MIRROR ASSEMBLY LH | 87940 | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 2 | OUTER MIRROR LH | 87961 | - | - | - |
| 3 | OUTER MIRROR COVER LH | 87945 | ( ) |
- | - |
| 4 | COVER BODY | - | ( ) |
- | - |
| 5 | SIDE TURN SIGNAL LIGHT ASSEMBLY LH | 81740 | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 6 | COVER BODY | - | ( ) |
- | - |
| 7 | SIDE TELEVISION CAMERA ASSEMBLY LH | 86790F | - | - | - |
| *1 | ACTUATOR SUB-ASSEMBLY | - | - |
| *1 | HARNESS SUB-ASSEMBLY | *2 | HOOK |
| *3 | GASKET | *4 | TELEVISION CAMERA WIRE |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the side television camera assembly removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87940 1.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
87961 2.REMOVE OUTER MIRROR LH
81740 5.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH
6.REMOVE COVER BODY
| *1 | Harness Sub-assembly | *2 | Television Camera Wire |
| *3 | Hook | - | - |
| *a | Cut here | - | - |
Cut the harness sub-assembly and the television camera wire at the location shown in the illustration.
Remove the screw.
Detach the guide and remove the hook.
|
Remove in this Direction | - | - |
Detach the guide and remove the gasket.
Detach the clamp and disconnect the 2 connectors.
Disconnect the 2 connectors and detach the guide.
|
Remove in this Direction | - | - |
Remove the 4 screws.
Using a thin-bladed screwdriver, disconnect the connector and remove the actuator sub-assembly.
Tape the thin-bladed screwdriver tip before use.
Remove the harness sub-assembly and the television camera wire.
Remove the cover body.
86790F 7.REMOVE SIDE TELEVISION CAMERA ASSEMBLY LH