Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR (for Quarter Pillar) › from 2021.07
RM38G0E _58 Vehicle Interior _100751 SUPPLEMENTAL RESTRAINT SYSTEMS _0467879 SIDE AIRBAG SENSOR(for Quarter Pillar) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR(for Quarter Pillar)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B609199N01
1,0.75 3.25,3 2.25,2.25 3.75,1 6,2.75 2.25,1.75 6.573,0.219 6.823,0.219 true 1.792,1.667 2.042,1.667 true 6.531,0.604 6.781,0.604 true 4.677,2.188 4.677,1.938 true 1.094,0.802 1.469,1.042 0.375,0.24 12 false *A 6.385,0.438 6.844,0.781 0.458,0.344 18 false 2 6.438,0.052 7.135,0.458 0.698,0.406 18 false 1 1.635,1.5 2.469,1.854 0.833,0.354 18 false 3 3.833,1.052 4.677,1.5 0.844,0.448 12 false *B, *C 4.604,2.146 5.438,2.5 0.833,0.354 18 false 4

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL - (Click here) - -
3 REAR NO. 2 SEAT ASSEMBLY - - - -
4 TONNEAU COVER ASSEMBLY 64910M - - -

*A w/ Rear No. 2 Seat *B w/o Rear No. 2 Seat
*C w/ Tonneau Cover - -

B610929N02
2.823,0.604 3.073,0.604 true 4.979,1.49 5.229,1.49 true 4.229,2.385 4.229,2.135 true 4.969,2.875 4.969,2.625 true 2.552,1.198 2.552,0.948 true 4.188,3.292 4.438,3.292 true 4.979,2.385 5.24,2.385 true 1.99,2.083 2.24,2.083 true 2.479,2.604 2.74,2.604 true 3.208,2.74 3.469,2.74 true 3.729,2.563 4.01,2.917 0.281,0.354 18 false 6 5.229,1.323 5.677,1.719 0.448,0.396 18 false 11 0.083,0.063 0.458,0.302 0.375,0.24 12 false *A 4.438,3.115 4.885,3.51 0.448,0.396 18 false 10 3.333,0.427 3.615,0.781 0.281,0.354 18 false 5 2.313,2.438 2.594,2.792 0.281,0.354 18 false 5 5.5,2.229 5.781,2.583 0.281,0.354 18 false 5 2.5,1.938 2.781,2.292 0.281,0.354 18 false 5 4.146,2.365 4.427,2.719 0.281,0.354 18 false 7 4.896,2.833 5.177,3.188 0.281,0.354 18 false 8 2.479,1.156 2.76,1.51 0.281,0.354 18 false 9

Procedure Part Name Code
Z101186

Z101188

Z101187

5 ROPE HOOK ASSEMBLY 66310N (Click here) - -
6 REAR DECK TRIM COVER 64716P (Click here) - -
7 DECK BOARD ASSEMBLY 58410B - - -
8 REAR FLOOR REAR BOARD LH 58418H - - -
9 REAR FLOOR REAR BOARD RH 58417B - - -
10 REAR DECK FLOOR BOX 64993 - - -
11 REAR FLOOR MAT REAR SUPPORT PLATE 58574G - - -

*A w/o Rear No. 2 Seat - -

B609553N03
0.083,0.083 2.833,2 2.75,1.917 4.667,1 7.083,3.167 2.417,2.167 3.167,0.417 4.5,1.167 1.333,0.75 1.333,2.083 2.583,3.083 1.25,1 5.583,0.083 7.083,0.917 1.5,0.833 4.073,3.208 4.073,2.958 true 5.99,2.625 5.99,2.375 true 2.24,1.51 2.24,1.26 true 2.313,2.75 2.313,2.5 true 3.854,1.875 4.104,1.875 true 3.552,1.708 3.552,1.458 true 3.615,0.771 3.865,0.771 true 6.302,0.771 6.552,0.771 true 6.281,3.646 6.573,3.646 true 3.927,2.698 4.479,3 0.552,0.302 18 false 12 3.417,1.198 3.969,1.5 0.552,0.302 18 false 13 4.104,1.698 4.656,2 0.552,0.302 18 false 14 6.552,0.594 7.104,0.896 0.552,0.302 18 false 15 4.083,0.635 4.635,0.938 0.552,0.302 18 false 16 2.177,2.698 2.729,3 0.552,0.302 18 false 16 5.854,2.583 6.406,2.885 0.552,0.302 18 false 17 2.104,1.469 2.656,1.771 0.552,0.302 18 false 18 6.792,3.5 7.146,3.802 0.354,0.302 18 false 19 4.729,1.042 5.042,1.24 0.313,0.198 12 false *A 0.146,0.115 0.698,0.417 0.552,0.302 12 false *B 5.635,0.115 5.948,0.313 0.313,0.198 12 false *C 3.229,0.448 3.542,0.646 0.313,0.198 12 false *D 1.396,2.115 1.708,2.313 0.313,0.198 12 false *D

Procedure Part Name Code
Z101186

Z101188

Z101187

12 REAR DOOR SCUFF PLATE LH 67918D - - -
13 OUTER LAP BELT ANCHOR COVER 73233D - - -
14 REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) 73370C - - -
15 REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) 73570 - - -
16 NO. 1 TONNEAU COVER HOLDER CAP 64937A (Click here) - -
17 QUARTER TRIM PANEL ASSEMBLY LH 62520B - - -
18 QUARTER TRIM PANEL ASSEMBLY RH 62510M - - -
19 NO. 2 SIDE AIRBAG SENSOR ASSEMBLY 89860C (Click here) - -

*A for LH Side *B for RH Side
*C w/ Rear No. 2 Seat *D w/ Tonneau Cover

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the No. 2 side airbag sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





Hide 3.REMOVE REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)

Hide 64910M 4.REMOVE TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat, w/ Tonneau Cover)

Hide 66310N 5.REMOVE ROPE HOOK ASSEMBLY (w/o Rear No. 2 Seat)

Z101186

Click here(Click here)

Hide 64716P 6.REMOVE REAR DECK TRIM COVER (w/o Rear No. 2 Seat)

Z101186

Click here(Click here)

Hide 58410B 7.REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)

Hide 58418H 8.REMOVE REAR FLOOR REAR BOARD LH (w/o Rear No. 2 Seat)

Hide 58417B 9.REMOVE REAR FLOOR REAR BOARD RH (w/o Rear No. 2 Seat)

a.

Use the same procedure described for the LH side.


Hide 64993 10.REMOVE REAR DECK FLOOR BOX (w/o Rear No. 2 Seat)

Hide 58574G 11.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)

Hide 67918D 12.REMOVE REAR DOOR SCUFF PLATE LH

Hide 73233D 13.REMOVE OUTER LAP BELT ANCHOR COVER

Hide 73370C 14.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)

Hide 73570 15.REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) (w/ Rear No. 2 Seat)

Hide 64937A 16.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)

Z101186

Click here(Click here)

Hide 62520B 17.REMOVE QUARTER TRIM PANEL ASSEMBLY LH (for LH Side)

Hide 62510M 18.REMOVE QUARTER TRIM PANEL ASSEMBLY RH (for RH Side)

Hide 89860C 19.REMOVE NO. 2 SIDE AIRBAG SENSOR ASSEMBLY

a.
B608600C01
0.583,0.667 1.167,0.667 true 4.208,0.094 4.531,0.417 0.323,0.323 18 false ii 0.438,0.563 0.708,0.771 0.271,0.208 10 false *a 0.625,0.094 0.948,0.417 0.323,0.323 18 false i
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B609556N01
0.719,0.063 1,0.417 0.281,0.354 18 false i 4.927,0 5.208,0.354 0.281,0.354 18 false ii 5.656,0.781 5.938,1.135 0.281,0.354 18 false iii

i.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Remove the bolt.

NOTICE:
·

Loosen the bolt while holding the No. 2 side airbag sensor assembly because the No. 2 side airbag sensor assembly guide is easily damaged.

·

If the No. 2 side airbag sensor assembly has been dropped, replace it with a new one.




iii.

Disengage the guide to remove the No. 2 side airbag sensor assembly.