| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( ) |
- | - |
| 2 | DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL | - | - | - | - |
| 3 | REAR WHEEL | - | - | - | - |
| *1 | REAR STABILIZER BUSH | *2 | REAR STABILIZER BAR BRACKET LH |
| *3 | REAR STABILIZER BAR BRACKET RH | *4 | LOWER BALL JOINT DUST COVER PROTECTOR |
| *5 | STABILIZER END BRACKET RH | *6 | REAR STABILIZER CUSHION |
| *7 | REAR NO. 1 STABILIZER BAR CUSHION RETAINER | *8 | REAR NO. 2 STABILIZER BAR CUSHION RETAINER |
| *9 | LOCK NUT | *10 | REAR STABILIZER CONTROL TUBE |
| *11 | UNION BOLT | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear stabilizer bar removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for F33A-FTV:
for V35A-FTS:
3.REMOVE REAR WHEEL
48802 6.DISCONNECT STABILIZER LINK SUB-ASSEMBLY
48805 7.DISCONNECT REAR STABILIZER BAR SUB-ASSEMBLY
Remove the nut and disconnect the rear stabilizer bar sub-assembly.
Do not lose the lower ball joint dust cover protector.
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
48805 8.REMOVE REAR STABILIZER BAR SUB-ASSEMBLY
48802 9.REMOVE STABILIZER LINK SUB-ASSEMBLY
| *1 | Stabilizer End Bracket RH | *2 | Rear Stabilizer Cushion |
| *3 | Rear No. 1 Stabilizer Bar Cushion Retainer | *4 | Rear No. 2 Stabilizer Bar Cushion Retainer |
| *5 | Lock Nut | - | - |
48885 10.REMOVE REAR STABILIZER CONTROL CYLINDER
488B2 11.REMOVE REAR NO. 2 STABILIZER CONTROL ARM
488B0 12.REMOVE REAR STABILIZER CONTROL ARM ASSEMBLY
48849D 13.REMOVE REAR STABILIZER LINK BUSH (for Rear Side)
| *1 | Rear Stabilizer Link Bush (Rear Side) | - | - |
Using a hammer and chisel, strike and bend the entire flange of the rear stabilizer link bush (rear side) as shown in the illustration.
Using SST and a press, press out the rear stabilizer link bush (rear side).
48849D 14.REMOVE REAR STABILIZER LINK BUSH (for Front Side)
| *1 | Rear Stabilizer Link Bush (Front Side) | - | - |
Using a hammer and chisel, strike and bend the entire flange of the rear stabilizer link bush (front side) as shown in the illustration.
Using SST and a press, press out the rear stabilizer link bush (front side).