| *1 | NO. 2 AIR HOSE | *2 | ENGINE OIL LEVEL DIPSTICK |
| *3 | GAS FILTER BRACKET | *4 | STARTER HOSE BRACKET SUB-ASSEMBLY |
| *5 | HOSE CLAMP | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
|
Engine oil |
| ● | Non-reusable part | *T1 | 1st: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 2nd: 8.0 N*m (82 kgf*cm, 71 in.*lbf) (12 or more minutes after 1st tightening) |
17940D 1.INSTALL INTERCOOLER ASSEMBLY
Install 2 new hose clamps to a new No. 2 air hose.
Thoroughly degrease the No. 2 air hose and the points where it connects to the vehicle before installation.
Temporarily install the intercooler assembly and No. 2 air hose with the 4 bolts and 2 hose clamps.
Tighten the 4 bolts.
Tighten the 2 hose clamps.
Retighten the 2 hose clamps after waiting 12 minutes or more.
Temporarily install the gas filter bracket with the 2 bolts.
Tighten the 2 bolts.
Connect the vacuum hose.
Connect the connector.
82712K 2.INSTALL WIRING HARNESS SUPPORT
12631A 3.INSTALL ENGINE COVER BRACKET
| *a | Identifying Mark D | - | - |
82121 4.CONNECT ENGINE WIRE
for RHD:
| *A | for Upper Side | *B | for Front Side |
| *C | for RH Side | *D | for LH Side |
| *E | for Cold Area Specification Vehicles | - | - |
for LHD:
| *A | for Upper Side | *B | for Front Side |
| *C | for RH Side | *D | for LH Side |
| *E | for Cold Area Specification Vehicles | *F | w/ Stop and Start System |
44360 5.CONNECT VANE PUMP OIL RESERVOIR ASSEMBLY
51448M 6.INSTALL ENGINE SIDE UNDER COVER RH
51470C 7.INSTALL REAR ENGINE SIDE UNDER COVER ASSEMBLY LH
51478C 8.INSTALL UPPER ENGINE SIDE UNDER COVER PLATE LH
16515A 9.INSTALL NO. 1 INTERCOOLER COOLING WATER PIPE
23100Y 10.INSTALL FUEL PRIMING PUMP ASSEMBLY
12142 11.INSTALL NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE
26100G 12.INSTALL DIESEL THROTTLE BODY ASSEMBLY
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
14. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
15.ADD COOLANT (for Intercooler)
16.INSPECT FOR COOLANT LEAK (for Intercooler)