Home › Engine / Hybrid System › 1HZ (LUBRICATION) › ENGINE OIL COOLER
RM25T0E _51 Engine / Hybrid System _029209 1HZ LUBRICATION _0133968 ENGINE OIL COOLER A

1HZ LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


PROCEDURE

Hide 15710 1.INSTALL OIL COOLER ASSEMBLY

a.

Install 2 new gaskets to the oil cooler assembly.


b.

Install the oil cooler assembly to the oil cooler cover sub-assembly with the 4 nuts.

Torque:
15.7 N*m (160 kgf*cm, 12 ft.*lbf)


Hide 15721 2.INSTALL OIL COOLER COVER

a.
A331872C01
0.635,0.313 0.792,0.51 0.156,0.198 10 false .
V100135

Nut
V100136

Bolt A
V100137

Bolt B


Install a new gasket and the oil cooler cover with the 2 nuts and 13 bolts.

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)

Bolt Length:
Item Specified Condition
Bolt A 27 mm (1.06 in.)
Bolt B 47 mm (1.85 in.)



Hide 16261 3.CONNECT WATER BY-PASS HOSE (w/ High Altitude Compensator)

a.

Connect the water by-pass hose to the oil cooler cover, and then slide the clamp to secure the hose.


Hide 89422A 4.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

Hide 11452 5.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

a.

Install a new O-ring to the engine oil level dipstick guide.


b.

Apply a small amount of clean engine oil to the O-ring.


c.

Install the engine oil level dipstick guide with the bolt.

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)


d.

Install the engine oil level dipstick.


Hide 15601 6.INSTALL OIL FILTER SUB-ASSEMBLY

Hide 22100 7.INSTALL INJECTION PUMP ASSEMBLY