1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
Click here
After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
67914 3.REMOVE FRONT DOOR SCUFF PLATE LH
for 4 Door: (Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Double Cab)>REMOVAL)
for 2 Door: (Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Single Cab)>REMOVAL)
67913 4.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
62112A 5.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
62111A 6.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
58191 7.REMOVE FRONT FLOOR FOOTREST
for LHD: (Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT FLOOR FOOTREST(for LHD)>REMOVAL)
for RHD: (Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT FLOOR FOOTREST(for RHD)>REMOVAL)
58811B 8.REMOVE CONSOLE BOX
89179A 9.REMOVE AIRBAG SENSOR COVER
89170 10.REMOVE AIRBAG SENSOR ASSEMBLY WITH AIRBAG SENSOR BRACKET (w/ Airbag System)
89441A 11.REMOVE DECELERATION SENSOR (w/ ABS)
36303 12.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
| *1 | Shift Lever Knob Sub-assembly (for Transfer Side) |
| *2 | Shift Lever Knob Sub-assembly (for Transmission Side) |
Twist the 2 shift lever knob sub-assembly in the direction indicated by the arrow and remove it.
58286 13.REMOVE NO. 1 SHIFT AND SELECT LEVER BOOT
Fold back the floor carpet until it is possible to remove the No. 1 shift and select lever boot.
Remove the front seat assembly if necessary.
for Separate Seat Type: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Separate Seat Type without Inner Belt Attached)>REMOVAL
for Bench Seat Type: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>REMOVAL
Remove the 6 bolts and No. 1 shift and select lever boot.
37140 14.REMOVE FRONT PROPELLER SHAFT ASSEMBLY
36323 15.REMOVE TRANSFER SHIFT LEVER GUIDE (for Direct Shift Type)
Tilt the manual transmission assembly until the transfer shift lever guide switch can be removed.
Click hereDrivetrain>R151F (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSMISSION ASSEMBLY>REMOVAL
Remove the nut, washer and wave washer.
Remove the 2 bolts and transfer shift lever guide.
Remove the front drive shift link lever bush.
36321 16.REMOVE FRONT TRANSFER DRIVE SHIFT LEVER (for Direct Shift Type)
Remove the nut, 2 washers and then remove the transfer shift lever shaft and wave washer.
Remove the clip, front transfer drive shift lever and 2 washers.
Remove the bush from the front transfer drive shift lever.
36322 17.REMOVE TRANSFER HIGH AND LOW SHIFT LEVER (for Vacuum Shift Type)
Remove the nut, wave washer and washer.
Remove the clip and then remove the high and low shift rod pin and transfer high and low shift lever.
Remove the 2 transfer shift lever bush, high and low shift rod grommet and high and low shift rod spacer from the transfer high and low shift lever.