When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.
When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.
23820A 1.INSTALL COMMON RAIL ASSEMBLY LH
Install the common rail assembly LH with the 2 bolts.
23765 2.INSTALL NO. 5 NOZZLE LEAKAGE PIPE
| *1 | No. 5 Nozzle Leakage Pipe |
| *2 | No. 1 Fuel Hose |
| *a | Clamp |
| *b | Union Bolt |
Install a new gasket and the No. 5 nozzle leakage pipe to the common rail assembly LH with the union bolt.
Make sure there is no foreign matter or damage on the seal surface.
Connect the No. 1 fuel hose and slide the clamp to secure the hose.
23802B 3.INSTALL NO. 2 FUEL PIPE SUB-ASSEMBLY
| *a | Clamp |
| *b | Union Bolt |
| *c | Bolt |
Install a new gasket and the No. 2 fuel pipe sub-assembly to the common rail assembly LH with the union bolt and bolt.
Connect the fuel hose and slide the clamp to secure the hose.
23810A 4.INSTALL COMMON RAIL ASSEMBLY RH
Install the common rail assembly RH with the 2 bolts.
Connect the fuel pressure sensor connector.
| *a | Torque Wrench Fulcrum Length |
Using a 17 mm union nut wrench, tighten the union nut on the common rail assembly RH.
34 N*m (347 kgf*cm, 25 ft.*lbf)
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 29.1 N*m (297 kgf*cm, 21 ft.*lbf)
23706 5.INSTALL NO. 6 INJECTION PIPE SUB-ASSEMBLY
6.INSTALL INJECTION PIPE
17940D 7.INSTALL INTERCOOLER ASSEMBLY
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9.ADD ENGINE COOLANT
10.BLEED AIR FROM FUEL SYSTEM
11. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
12.INSPECT FOR FUEL LEAK
13.INSPECT FOR OIL LEAK
14.INSPECT FOR COOLANT LEAK