Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF SUNSHADE SYSTEM
RM37H0E _58 Vehicle Interior _095304 INTERIOR PANELS / TRIM _0454452 ROOF SUNSHADE SYSTEM C

INTERIOR PANELS / TRIM  ROOF SUNSHADE SYSTEM  B2343  Position Initialization Incomplete  


DESCRIPTION

This DTC is stored when the sliding roof drive gear sub-assembly has not been initialized.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B2343 Position Initialization Incomplete Sliding roof drive gear sub-assembly has not been initialized. Sliding roof drive gear sub-assembly Sliding Roof B

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:
·

The roof sunshade system uses the LIN communication system. First, confirm that there are no malfunctions in the LIN communication system. Refer to How to Proceed with Troubleshooting.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF SUNSHADE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

·

If the sliding roof drive gear sub-assembly is removed and reinstalled or replaced, the sliding roof drive gear sub-assembly must be initialized.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF SUNSHADE SYSTEM>INITIALIZATION



HINT:

When DTC B2342 and B2343 are output simultaneously, perform troubleshooting for DTC B2342 first.


PROCEDURE

1.INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
a.

Check that the sliding roof drive gear sub-assembly can be initialized.

HINT:

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF SUNSHADE SYSTEM>INITIALIZATION


OK:

Sliding roof drive gear sub-assembly can be initialized.



Result:
Proceed to
OK
NG



OK

2.CHECK ROOF SUNSHADE OPERATION

NG

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

2.CHECK ROOF SUNSHADE OPERATION
a.

Check the roof sunshade auto operation.

HINT:

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF SUNSHADE SYSTEM>OPERATION CHECK


OK:

Auto operation operates normally.



Result:
Proceed to
OK
NG



OK

3.CHECK FOR DTC

NG

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

3.CHECK FOR DTC

Pre-procedure1

a.

Clear the DTCs.

Body Electrical > Sliding Roof > Clear DTCs
50002 147

Procedure1

a.

Check for DTCs.

Body Electrical > Sliding Roof > Trouble Codes
50001 147

Result:
Result Proceed to
DTCs are not output A
DTCs are output B


Post-procedure1

a.

None



A

END (MALFUNCTION DUE TO INITIALIZATION FAILURE)

B

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY