Home › Drivetrain › Q710 (HYBRID TRANSMISSION / TRANSAXLE) › ELECTRONIC SHIFT LEVER SYSTEM
RM37H0E _52 Drivetrain _093826 Q710 HYBRID TRANSMISSION / TRANSAXLE _0454877 ELECTRONIC SHIFT LEVER SYSTEM T

Q710 HYBRID TRANSMISSION / TRANSAXLE  ELECTRONIC SHIFT LEVER SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the problem symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Electronic Shift Lever System
Symptom Suspected Area Link
The shift position indicator does not come on. P position switch indicator circuit Click here
The shift position indicator does not go off. P position switch indicator circuit Click here
The shift state cannot be changed from park (P) to any other state. The brake pedal was not depressed or was depressed lightly Click here
Shift lever was moved when READY indicator was blinking
Shift lever was moved to Br
Shift lever was moved when READY indicator was not illuminated
Electronic shift lever system overheat fail-safe function operating (Wait for a while and then attempt to change the shift state again)
Shift lever was moved when accelerator pedal was depressed
Auxiliary battery is discharged or voltage is low Click here
Shift operation is performed while READY indicator is off with vehicle stopped on a slope. Click here
The shift state cannot be changed to park (P). P position switch was operated while driving Click here
P position switch and shift lever were operated simultaneously
Auxiliary battery is discharged or voltage is low Click here
"P" position switch circuit Click here
The shift state changed to park (P) unintentionally. P position switch was operated unintentionally -
Ignition switch was turned off -
"P" position switch circuit
(Fail-safe function temporarily operating)
Click here
Driver exited vehicle when shift position was not P
(Open the door, Front LH seat belt not fastened, Brake pedal was not depressed)
Click here
The shift state cannot be changed to brake (Br). Shift lever was moved to Br when shift state other than drive (D) was selected Click here
Auxiliary battery is discharged or voltage is low Click here
The shift state cannot be changed to neutral (N). Shift lever operation time was too short (Hold the shift lever in N for a short time) -
Shift lever was not held in N long enough while stopped or driving at low speed Click here
The shift state changed to a different state than intended according to shift lever operation. After selecting shift state, shift lever was manually returned and was moved to another position unintentionally Click here
The shift state changed to neutral (N) unintentionally. Shift lever was operated while driving or moved due to an object hanging from it Click here
Shift lever was moved to D when backing up
Shift lever was moved to R while driving forward
Shift lever returned too slowly
Auxiliary battery is discharged or voltage is low Click here
A temporary malfunction was detected
(shift sensor malfunction (logical inconsistency))
Click here
P position switch was pressed repeatedly when driving Click here
P position switch was pressed and held unintentionally when driving
The shift state cannot be changed to drive (D) or reverse (R). READY indicator was not illuminated Click here
Shift lever was moved to D when backing up
Shift lever was moved to R while driving forward
Shift lever returned too slowly
Shift lever was not moved fully or operation time was too short
Auxiliary battery is discharged or voltage is low Click here
Has forced parking lock release procedure history Click here
Brake pedal was not depressed or was depressed lightly Click here
Shift lever was moved with accelerator pedal depressed Click here
Shift indicator is off (shift pattern is displayed but no shift state selected is displayed) Auxiliary battery is discharged or voltage is low Click here
Ignition switch does not turn on (READY). Shift control actuator assembly malfunction was detected Click here
Unable to turn off the power. To turn off the power, operate the ignition switch after operating the P position switch. -
"Battery low Shifting unavailable See owner's manual" is displayed. Auxiliary battery is discharged or voltage is low Click here
"Stop vehicle in a safe place Push P switch" is displayed. Auxiliary battery is discharged or voltage is low Click here
Ignition switch was repeatedly operated or pressed and held while driving, causing the hybrid system to stop but the shift state did not automatically change to park (P)
Check if the DTCs related to electronically controlled brake system are output
Click here
Proceed to ""Stop vehicle in a safe place Push P switch" is Displayed on Multi-information Display." Click here
"Shift system unavailable Apply parking brake securely when parking See owner's manual" is displayed. Ignition switch was pressed repeatedly or pressed and held to stop hybrid system before vehicle was stopped Click here
Auxiliary battery is discharged or voltage is low Click here
"P" position switch circuit
(Fail-safe function temporarily operating)
Click here
"Shift system malfunction Stop in a safe place See owner's manual" is displayed. A temporary malfunction was detected
(shift sensor malfunction (logical inconsistency))
Click here
Advanced Park mode is suspended or canceled. Shift lever was moved during Advanced Park Click here
P position switch was operated during Advanced Park Click here