| *1 | CABLE SUPPORT BRACKET | *2 | PARKING BRAKE SHOE HOLD DOWN SPRING CUP |
| *3 | PARKING BRAKE SHOE HOLD DOWN COMPRESSION SPRING | *4 | PARKING BRAKE SHOE HOLD DOWN SPRING PIN |
|
High temperature grease | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the parking brake assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, theservo motor and expansion valve standardposition is recognized. | - |
Use the same procedure for the RH and LH side.
The procedure listed below is for the LH side.
1. PRECAUTION
3.REMOVE REAR WHEEL
47491A
5.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
46550A
7.REMOVE NO. 1 PARKING BRAKE SHOE RETURN TENSION SPRING
Using SST, remove the No. 1 parking brake shoe return tension spring.
46550E
8.REMOVE NO. 2 PARKING BRAKE SHOE RETURN TENSION SPRING
Using SST, remove the No. 2 parking brake shoe return tension spring.
47406A
9.REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET
Slide the parking brake shoe and remove the parking brake shoe adjusting screw set.
46590
10.REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH
Using SST, remove the parking brake shoe hold down spring cup, parking brake shoe hold down compression spring and parking brake shoe hold down spring pin.
Remove the No. 2 parking brake shoe assembly LH.
46580
11.REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
Using SST, remove the parking brake shoe hold down spring cup, parking brake shoe hold down compression spring and parking brake shoe hold down spring pin.
Remove the No. 1 parking brake shoe assembly LH.
46602
12.REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY LH
Slide the parking brake shoe lever sub-assembly LH.
Separate the parking brake cable to remove the parking brake shoe lever sub-assembly LH.
13.DISCONNECT PARKING BRAKE CABLE
42450B
14.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH
46505
15.REMOVE PARKING BRAKE ANCHOR BLOCK SUB-ASSEMBLY