| ★ | Precoated part | ● | Non-reusable part |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear drive shaft assembly removal/installation are shown below.
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the rear disc brake pads, the brake pedal may feel soft due to clearance between the rear disc brake pads and rear disc. Depress the brake pedal several times until the brake pedal feels firm.
After replacing the rear disc brake pads, always perform a road test to check the braking performance and check for vibrations.
When removing or installing the rear disc brake cylinder assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C13DB00, C13DC00, C13DD00, C13DE00, C140000 and/or C140A00 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this procedure.
While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, theservo motor and expansion valve standardposition is recognized. | - |
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
52383E
1.REMOVE NO. 1 DIFFERENTIAL SUPPORT PROTECTOR
52384C
2.REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR
53661B
3.REMOVE REAR SUSPENSION BRACE COVER
52296
4.REMOVE REAR SUSPENSION MEMBER BRACE LH
52295
5.REMOVE REAR SUSPENSION MEMBER BRACE RH
Use the same procedure as for the LH side.
6.DRAIN HYBRID TRANSAXLE FLUID
7.REMOVE REAR AXLE ASSEMBLY LH
8.REMOVE REAR AXLE ASSEMBLY RH
Use the same procedure as for the LH side.
42340B
9.REMOVE REAR DRIVE SHAFT ASSEMBLY LH
Using SST, remove the rear drive shaft assembly LH.
Do not damage the oil seal, boot and dust cover.
Do not drop the rear drive shaft assembly LH.
When carrying the rear drive shaft assembly LH, hold it horizontally.
Hook the SST claw at the position shown in the illustration to remove the rear drive shaft assembly LH.
42330
10.REMOVE REAR DRIVE SHAFT ASSEMBLY RH
Use the same procedure as for the LH side.
43425B
11.REMOVE DRIVE SHAFT SNAP RING LH
Using a screwdriver, remove the shaft snap ring.
Do not damage the shaft spline.
43425A
12.REMOVE DRIVE SHAFT SNAP RING RH
Use the same procedure as for the LH side.