Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM37H0E _58 Vehicle Interior _095292 SEAT _0457025 SEAT HEATER SYSTEM J

SEAT  SEAT HEATER SYSTEM  Seat Heater for Front Right Seat does not Operate  


DESCRIPTION

When the seat heater switch (front right side) is operated, the air conditioning amplifier assembly receives the signal. The air conditioning amplifier assembly receives the signal and operates the front right side seat heater.

WIRING DIAGRAM

E444468E12
0.198,4.844 1.792,5.208 1.594,0.365 10 false Air Conditioning Amplifier Assembly 2.104,4.49 3.365,4.917 1.26,0.427 10 false Seat Heater Control Sub-assembly RH 3.917,4.479 5.646,4.854 1.729,0.375 10 false Front Seat Cushion Heater Assembly RH 5.729,4.448 7.125,4.802 1.396,0.354 10 false Front Seatback Heater Assembly RH 0.719,5.396 2.49,5.583 1.771,0.188 10 false : LIN Communication Line 5.552,0.99 7.031,1.573 1.479,0.583 10 false Air Conditioning Control Assembly 1.948,1.094 2.802,1.417 0.854,0.323 10 false A/C NO. 2 3.167,0.958 4.688,1.146 1.521,0.188 10 false from A/C Relay 5.625,0.469 6.115,0.698 0.49,0.229 10 false LIN1 0.917,0.469 1.344,0.792 0.427,0.323 10 false LIN1 2.104,4.333 2.385,4.51 0.281,0.177 10 false L14 2.177,2.865 2.5,3.042 0.323,0.177 10 false +B1 2.177,3.906 2.563,4.083 0.385,0.177 10 false SWR 3.125,2.885 3.354,3.063 0.229,0.177 10 false E 2.896,3.917 3.302,4.094 0.406,0.177 10 false HTR1 0.24,4.656 0.667,4.896 0.427,0.24 10 false D79 0.823,3.927 1.281,4.094 0.458,0.167 10 false SM1R 1.302,3.792 1.563,4.073 0.26,0.281 10 false 14 1.948,3.792 2.094,3.958 0.146,0.167 10 false 5 1.969,2.771 2.115,2.938 0.146,0.167 10 false 1 3.344,2.76 3.552,2.938 0.208,0.177 10 false 10 3.365,3.792 3.51,3.979 0.146,0.188 10 false 7 3.948,4.271 4.365,4.573 0.417,0.302 10 false L10 4.156,3.813 4.281,4 0.125,0.188 10 false 1 4.167,2.76 4.479,3.052 0.313,0.292 10 false 6 4.146,1.823 4.375,2.073 0.229,0.25 10 false 2

CAUTION / NOTICE / HINT

NOTICE:
·

If the auxiliary battery voltage is low, the seat heater system may not operate. When "High Power Consumption Partial Limit on AC/Heater Operation" is displayed on the multi-information display in the combination meter assembly, inspect the auxiliary battery, referring to On-vehicle Inspection for the charging system.

Click herePower Source / Network>BATTERY / CHARGING>CHARGING SYSTEM>ON-VEHICLE INSPECTION

·

If the seat heater system is operated when the auxiliary battery voltage is low, due to the electrical load limit control that gives voltage supply priority to the power steering system, the seat heater system may not operate. In this case, check the vehicle control history of the power steering system and check that "Battery Voltage Drop: X208F" is not stored before proceeding with troubleshooting.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>VEHICLE CONTROL HISTORY

·

Inspect the fuses for circuits related to this system before performing the following procedure.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (SEAT HEATER)
a.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Front Right Seat Heater Front right side seat heater operation OFF/ON -
Body Electrical > Air Conditioner > Active Test
Tester Display
Front Right Seat Heater
50004 121 116
OK:

Front right side seat heater operates normally.



Result:
Proceed to
OK
NG



OK

2.CHECK SEAT HEATER OPERATION

NG

3.CHECK HARNESS AND CONNECTOR (SEAT HEATER CONTROL SUB-ASSEMBLY RH - BATTERY)
2.CHECK SEAT HEATER OPERATION
a.

Check the seat heater operation.

Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>OPERATION CHECK

OK:

The seat heater operates normally.



Result:
Result Proceed to
Does not operate normally with operation of either the multi-display or seat blower switch A
Does not operate normally with operation of the multi-display B
Does not operate normally with operation of the seat blower switch C



A

B

C

3.CHECK HARNESS AND CONNECTOR (SEAT HEATER CONTROL SUB-ASSEMBLY RH - BATTERY)
a.

Disconnect the L14 seat heater control sub-assembly RH connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(L14)Location & Routing

Click Connector(L14)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Heater Control Sub-Assembly RH

L14-1 (+B1) - Body ground Ignition switch ON 11 to 14 V
L14-1 (+B1) - Body ground Ignition switch off Below 1 V



Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEAT HEATER CONTROL SUB-ASSEMBLY RH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - SEAT HEATER CONTROL SUB-ASSEMBLY RH)
a.

Disconnect the D79 air conditioning amplifier assembly connector.


b.

Disconnect the L14 seat heater control sub-assembly RH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D79,L14)Location & Routing

Click Connector(D79)Instrument Panel>Instrument Panel Wire>Air Conditioning Amplifier Assembly

Click Connector(L14)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Heater Control Sub-Assembly RH

D79-14 (SM1R) - L14-5 (SWR) Always Below 1 Ω
D79-14 (SM1R) or L14-5 (SWR) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.CHECK HARNESS AND CONNECTOR (FRONT SEAT CUSHION HEATER ASSEMBLY RH - SEAT HEATER CONTROL SUB-ASSEMBLY RH AND BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.CHECK HARNESS AND CONNECTOR (FRONT SEAT CUSHION HEATER ASSEMBLY RH - SEAT HEATER CONTROL SUB-ASSEMBLY RH AND BODY GROUND)
a.

Disconnect the L10 front seat cushion heater assembly RH connector.


b.

Disconnect the L14 seat heater control sub-assembly RH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(L10,L14)Location & Routing

Click Connector(L10)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Cushion Heater Assembly RH

Click Connector(L14)Seat>Front Seat Wire RH / No. 2 Front Seat Wire LH / No. 2 Front Seat Wire RH>Front Seat Heater Control Sub-Assembly RH

L10-6 - L14-10 (E) Always Below 1 Ω
L10-6 or L14-10 (E) - Body ground Always 10 kΩ or higher
L10-1 - L14-7 (HTR1) Always Below 1 Ω
L10-1 or L14-7 (HTR1) - Body ground Always 10 kΩ or higher
L10-2 - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

6.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH

OK

7.INSPECT FRONT SEATBACK HEATER ASSEMBLY RH

NG

REPLACE FRONT SEAT CUSHION HEATER ASSEMBLY RH

7.INSPECT FRONT SEATBACK HEATER ASSEMBLY RH

Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER>INSPECTION

Result:
Proceed to
OK
NG



OK

8.REPLACE SEAT HEATER CONTROL SUB-ASSEMBLY RH

NG

REPLACE FRONT SEATBACK HEATER ASSEMBLY RH

8.REPLACE SEAT HEATER CONTROL SUB-ASSEMBLY RH
a.

Replace the seat heater control sub-assembly RH with a new or known good one.

Click hereVehicle Interior>SEAT>SEAT HEATER CONTROL (for Front Seat)>REMOVAL


Result:
Proceed to
NEXT



NEXT

9.CHECK FRONT SEAT HEATER OPERATION
9.CHECK FRONT SEAT HEATER OPERATION
a.

Check the front right side seat heater operation.

Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>OPERATION CHECK

OK:

Front right side seat heater operates normally.



Result:
Proceed to
OK
NG



OK

END (SEAT HEATER CONTROL SUB-ASSEMBLY RH WAS DEFECTIVE)

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY